Data Sheet
ADGM1144
0 Hz/DC to 18 GHz, SP4T, MEMS Switch
The ADGM1144 has integrated 10 MΩ resistors required for floating
node avoidance. The presence of these integrated 10 MΩ resistors
saves board space and eliminates floating nodes on the switch. To
ensure optimum operation of the ADGM1144, refer to the Critical
Operational Requirements section.
FEATURES
► Fully operational from DC to 18 GHz (typical)
► RF performance characteristics
► Insertion loss: −1.7 dB (typical) at 16 GHz
► Isolation: −18.5 dB (typical) at 6 GHz
► IIP3: 73 dBm (typical)
Throughout this data sheet, multifunction pins, such as IN1/SDI, are
referred to either by the entire pin name or by a single function of
the pin, for example IN1, when only that function is relevant.
► RF power: 33 dBm (maximum)
► On resistance: 1.9 Ω (typical)
► DC current handling: 200 mA
COMPANION PRODUCTS
► Quad PMU : AD5522
► MEMS Switch: ADGM1304, ADGM1004, ADGM1001,
ADGM1002, ADGM1003
► Actuation lifetime: 200 million cycles (minimum)
► On switching time: 200 µs (typical)
► Integrated 3.3 V driver for simple control with parallel and SPI
interface
► Low Noise, LDO : ADP7142, LT1962, LT3045-1
► Independently controllable switches
► Space saving integrated passive components
► Eliminates floating nodes on the switch
FUNCTIONAL BLOCK DIAGRAM
► 5 mm × 4 mm × 1.0 mm, 24-lead land grid array package
► Temperature range: −40°C to +85°C
► Switch position is unknown with no supply voltage
APPLICATIONS
► Automatic test equipment (ATE) load and probe boards
► DC with high speed digital testing
► Relay replacements
► RF test instrumentation
► ATE: RF, digital, and mixed signals
► RF wireless communications
Figure 1.
► High performance RF switching
GENERAL DESCRIPTION
The ADGM1144 is a wideband, single-pole, four-throw (SP4T)
switch, fabricated using Analog Devices, Inc., microelectromechani-
cal system (MEMS) switch technology. This technology enables a
small form factor, wide RF bandwidth, highly linear, low insertion
loss switch that is operational down to 0 Hz/DC, making it an ideal
solution for a wide range of RF and precision equipment switching
needs.
An integrated driver chip generates a high voltage to an electrostat-
ically actuate switch that can be controlled by a parallel interface
and a serial peripheral interface (SPI). All four switches are inde-
pendently controllable.
The device is packaged in a 24-lead, 5 mm × 4 mm × 1.0 mm land
grid array package (LGA).
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable "as is". However, no responsibility is assumed by Analog
Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to
change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
DOCUMENT FEEDBACK
TECHNICAL SUPPORT