NXP Semiconductors
Data Sheet: Technical Data
K63P144M120SF5
Rev. 7, 11/2016
Kinetis K63F Sub-Family Data
MK63FN1M0VLQ12
MK63FN1M0VMD12
Sheet
120 MHz ARM® Cortex®-M4-based Microcontroller with FPU
The K63 product family members are optimized for cost-sensitive
applications requiring low-power, USB/Ethernet connectivity, up
to 256 KB of embedded SRAM and the need for extensive
tamper protection, such as Electronic Point of Sales. These
devices share the comprehensive enablement and scalability of
the Kinetis family.
This product offers:
144 LQFP
20 x 20 x 1.6 mm Pitch 13 x 13 x 1.46 mm
0.5 mm Pitch 1 mm
144 MAPBGA
• Run power consumption down to 250 μA/MHz. Static
power consumption down to 5.8 μA with full state retention
and 5 μs wakeup. Lowest Static mode down to 339 nA
• DryIce Tamper Detection with active/passive pin,
temperature, clock, supply voltage monitoring
• USB LS/FS OTG 2.0 with embedded 3.3 V, 120 mA LDO Vreg, with USB device crystal-less operation
• 10/100 Mbit/s Ethernet MAC with MII and RMII interfaces
Performance
• Up to 120 MHz ARM® Cortex®-M4 core with DSP
Communication interfaces
• Ethernet controller with MII and RMII interface
• USB full-/low-speed On-the-Go controller
• Controller Area Network (CAN) module
• Three SPI modules
instructions and floating point unit
Memories and memory interfaces
• Up to 1 MB program flash memory and 256 KB RAM
• FlexBus external bus interface
• Three I2C modules. Support for up to 1 Mbit/s
• Six UART modules
• Secure Digital Host Controller (SDHC)
• I2S module
System peripherals
• Multiple low-power modes, low-leakage wake-up unit
• Memory protection unit with multi-master protection
• 16-channel DMA controller
Timers
• Two 8-channel Flex-Timers (PWM/Motor control)
• Two 2-channel FlexTimers (PWM/Quad decoder)
• IEEE 1588 timers
• 32-bit PITs and 16-bit low-power timers
• Real-time clock
• External watchdog monitor and software watchdog
Security and integrity modules
• Hardware CRC module
• Tamper detect and secure storage
• Hardware random-number generator
• Hardware encryption supporting DES, 3DES, AES,
MD5, SHA-1, and SHA-256 algorithms
• 128-bit unique identification (ID) number per chip
• Programmable delay block
Clocks
• 3 to 32 MHz and 32 kHz crystal oscillator
• PLL, FLL, and multiple internal oscillators
• 48 MHz Internal Reference Clock (IRC48M)
Analog modules
• Two 16-bit SAR ADCs
• Two 12-bit DACs
Operating Characteristics
• Voltage range: 1.71 to 3.6 V
• Three analog comparators (CMP)
• Voltage reference
• Flash write voltage range: 1.71 to 3.6 V
• Temperature range (ambient): –40 to 105°C
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.