24LCS22A
2K VESA® E-EDID™ Serial EEPROM
Features
Package Types
PDIP/SOIC
• Single supply with operation down to 2.5V
• Supports Enhanced EDID™ (E-EDID™) 1.3
• Completely implements DDC1/DDC2™ interface
for monitor identification, including recovery to
DDC1
*NC
*NC
1
2
8
7
VCC
VCLK
• 2K-bit Serial EEPROM Low-power CMOS
technology:
WP
VSS
3
4
6
5
SCL
SDA
- 1 mA typical active current
- 10 µA standby current typical at 5.5V
• 2-wire serial interface bus, I2C™ compatible
• 100 kHz (2.5V) and 400 kHz (5V) compatibility
• Self timed write cycle (including auto-erase)
• Hardware write-protect pin
* Pins labeled ‘NC’ have no internal connection
• Page write buffer for up to eight bytes
• 1,000,000 erase write cycles
Block Diagram
• Data retention > 200 years
WP
• ESD protection > 4000V
HV Generator
• 8-pin DIP and SOIC packages
• Available temperature ranges:
I/O
Control
Logic
Memory
Control
Logic
- Industrial (I)
-40°C to +85°C
EEPROM
Array
XDEC
Description
Page Latches
The Microchip Technology Inc. 24LCS22A is a 256 x 8-bit
dual-mode Electrically Erasable PROM (EEPROM). This
device is designed for use in applications requiring
storage and serial transmission of configuration and
control information. Two modes of operation have been
implemented: Transmit-only mode (1K-bit) and
Bidirectional mode (2K-bit). Upon power-up, the device
will be in the Transmit-only mode, sending a serial bit
stream of the memory array from 00h to 7Fh, clocked by
the VCLK pin. A valid high-to-low transition on the SCL pin
will cause the device to enter the Transition mode, and
look for a valid control byte on the I2C bus. If it detects a
valid control byte from the master, it will switch into
Bidirectional mode, with byte selectable read/write
capability of the entire 2K memory array using SCL. If no
control byte is received, the device will revert to the
Transmit-only mode after it receives 128 consecutive
VCLK pulses while the SCL pin is idle. The 24LCS22A is
available in standard 8-pin DIP and SOIC packages. The
24LCS22A features a flexible Write-Protect pin which is
enabled by writing to address 7Fh (usually the checksum
in VESA® applications.
SDA
SCL
YDEC
VCLK
Sense Amp.
R/W Control
Vcc
Vss
2003 Microchip Technology Inc.
DS21682B-page 1