THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
CW 0535
VPLD31TEM
669.3266M
3.3V SURFACE MOUNT VCXO OSCILLATOR
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
VPLD31TEM
Storage Temperature
Supply Voltage
-40
-0.5
-0.5
-
-
-
85
7.0
7.0
(Vcc)
(Vc)
Vdc
Vdc
Control Voltage
DESCRIPTION
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
The Connor-Winfield
MINIMUM NOMINAL MAXIMUM
UNITS
622.08000
644.53125
666.51430
VPLD31TEM is a 3.3V Voltage
Controlled Crystal Oscillator
(VCXO) with Differential
-
-
Center Frequency
(Fo)
669.32660
MHz
ppm
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-25
-
-
25
1
LVPECLoutputs and
0
85
°C
Enable/Disable function. The
VPLD31TEM is designed for
use with PLL systems requiring
low jitter and tight stability. No
PLL multiplication schemes are
used in this oscillator design.
(Vcc)
(Icc)
3.135
3.3
-
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
100
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 80MHz)
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
-
5
1
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-60
-90
-130
-135
-
-
-
INPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
ppm
%
Control Voltage Range
Absolute Pull Range (APR)
Monotonic Linearity
(Vc)
0.3
+/-25
-10
-
1.65
3.0
-
-
2
FEATURES
-
10
Input Impedance
50K
-
Ohm
KHz
Vdc
Vdc
-
-
-
Modulation Bandwidth (3dB)
Enable Input Voltage (Low)
Disable Input Voltage (High)
10
-
1.68
-
LOW PROFILE, SURFACE MOUNT
PACKAGE
(Vil)
-
3
3
(Vih)
2.275
3.3V OPERATION
LVPECL OUTPUT CHARACTERISTICS
PARAMETER
TABLE 4.0
NOTE
4
MINIMUM NOMINAL MAXIMUM
UNITS
Ohms
Vdc
Vdc
%
LOW JITTER <1pS RMS
LOAD
-
-
-
50
-
Voltage
(High)
(Low)
(Voh)
(Vol)
2.275
FREQUENCY TOLERANCE: ±25ppm
TEMPERATURE RANGE: 0 to 85°C
DIFFERENTIAL LVPECLOUTPUTS
ENABLE / DISABLE FUNCTION
TAPEAND REEL PACKAGING
-
45
-
-
1.68
55
Duty Cycle at 50% Level
50
-
Rise / Fall Time measured @ 20% to 80%
1.0
nS
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Non-hermetic package consisting of an FR4 substrate with grounded metal
cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
The component solder used internal to this device has a melting point of
221°C. The peak temperature inside the device should be less than or
equal to 220°C for a maximum of 10 seconds
ORDERING INFORMATION
Wash
Notes
1.0
2.0
Ultrasonic cleaning is not recommended.
VPLD31TEM - 669.3266MHz
Inclusive of calibration @25°C, frequency vs. temperature, aging (15yrs), supply and load variations, shoc k, and vibration.
Absolute Pull Range (APR) is the minimum guarant eed pull range of the VCXO under all conditions over lifetime
operation. The APR is referenced to Fo
When oscillator is disabled the true output i s in a low state (Vol) and the complementary output is in the high state (VoH)
50 ohm termination into Vcc-2V or Thevein equivalent.
VCXO
SERIES
CENTER
FREQUENCY
3.0
4.0
Specifications subject to change without notice.
09/20/05
Vx530
1
2
01
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a