UCC28019
www.ti.com
SLUS755B–APRIL 2007–REVISED DECEMBER 2007
8-Pin Continuous Conduction Mode (CCM) PFC Controller
1
FEATURES
DESCRIPTION
•
8-pin Solution Without Sensing Line Voltage
Reduces External Components
The UCC28019 8-pin active Power Factor Correction
(PFC) controller uses the boost topology operating in
Continuous Conduction Mode (CCM). The controller
is suitable for systems in the 100 W to >2 kW range
over a wide-range universal ac line input. Startup
current during under-voltage lockout is less than 200
µA. The user can control low power standby mode by
pulling the VSENSE pin below 0.77 V.
•
•
•
•
•
•
•
•
Wide-Range Universal AC Input Voltage
Fixed 65-kHz Operating Frequency
Maximum Duty Cycle of 97%
Output Over/Under-Voltage Protection
Input Brown-Out Protection
Low-distortion wave-shaping of the input current
using average current mode control is achieved
without input line sensing, reducing the Bill of
Materials component count. Simple external networks
allow for flexible compensation of the current and
voltage control loops. The switching frequency is
internally fixed and trimmed to better than 5%
accuracy at 25°C. Fast 1.5-A gate peak current drives
the external switch.
Cycle-by-Cycle Peak Current Limiting
Open Loop Detection
Low-Power User Controlled Standby Mode
APPLICATIONS
•
CCM Boost Power Factor Correction Power
Converters in the 100 W to >2 kW Range
Server and Desktop Power Supplies
Telecom Rectifiers
Industrial Electronics
Home Electronics
•
•
•
•
Numerous system-level protection features include
peak current limit, soft over-current detection,
open-loop detection, input brown-out detection,
output
over-voltage
protection/under-voltage
detection, a no-power discharge path on VCOMP,
and overload protection on ICOMP. Soft-Start limits
boost current during start-up. A trimmed internal
reference provides accurate protection thresholds
and regulation set-point. An internal clamp limits the
gate drive voltage to 12.5 V.
CONTENTS
•
•
•
•
•
Electrical Characteristics 3
Device Information 10
Application Information 12
Design Example 23
Additional References 43
TYPICAL APPLICATION DIAGRAM
VOUT
EMI Filter
LINE
INPUT
Bridge
Rectifier
–
+
GND
GATE
VCC
1
2
3
4
8
7
6
5
Auxilary
Supply
ICOMP
ISENSE VSENSE
VINS
VCOMP
Rload
UCC28019
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2007, Texas Instruments Incorporated