TPS43330-Q1
TPS43332-Q1
www.ti.com
SLVSA82A –MARCH 2011–REVISED NOVEMBER 2011
LOW IQ, SINGLE BOOST, DUAL SYNCHRONOUS BUCK
CONTROLLER
Check for Samples: TPS43330-Q1, TPS43332-Q1
1
FEATURES
•
•
•
Two Synchronous Buck Controllers
•
•
Sense Resistor or Inductor DCR Sensing
One Pre-Boost Controller
Out of Phase Switching between Buck
Channels
Input Range up to 40V, (Transients up to 60V),
Operation Down to 2V when Boost is Enabled
•
•
Peak Gate Drive Current 1.5 A
•
Low Power Mode IQ: 30µA (one Buck on), 35µA
(Two Bucks on)
Thermally Enhanced Package – 38-Pin
HTSSOP (DAP) with PowerPadTM
•
•
•
•
Low Shutdown Current Ish < 4 µA
Buck Output Range 0.9V to 11V
Boost Output Selectable: 7V/10V/11V
•
Qualified for Automotive Applications
APPLICATIONS
•
Automotive Start-Stop, Infotainment,
Navigation Instrument Cluster Systems
Programmable frequency and External
Synchronization Range 150kHz to 600kHz
•
Industrial/Automotive Multi-Rail DC Power
Distribution Systems & Electronic Control
Units
•
•
•
Separate Enable Inputs (ENA, ENB)
Frequency Spread Spectrum (TPS43332)
Selectable Forced Continuous Mode or
Automatic Low Power Mode at Light Loads
DESCRIPTION
The TPS43330-Q1/TPS43332-Q1 includes two current mode synchronous buck controllers and a voltage mode
boost controller. The part is ideally suited as pre-regulator stage with low Iq requirements and systems that need
to survive supply drops due to cranking events. The integrated boost controller allows the device to operate down
to 2V at the input without seeing a drop on the Buck regulator output stages. At light loads, the buck controllers
can be enabled to operate automatically in Low Power Mode consuming just 30µA of quiescent current.
The buck controllers have independent soft start capability and power good indicators. External MOSFET
protection is provided by current fold back in the buck controllers and cycle-by-cycle current limitation in the
boost controller. The switching frequency can be programmed over 150 kHz to 600 kHz or synchronized to an
external clock in the same range. Additionally, the TPS43332-Q offers frequency-hopping spread spectrum
operation.
VBAT
VBuckA
TPS43330/2
VBuckB
2 V
Figure 1. Typical Application Diagram
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Copyright © 2011, Texas Instruments Incorporated
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.