TPS43333-Q1
www.ti.com
SLVSB48B –AUGUST 2012–REVISED APRIL 2013
LOW IQ, SINGLE BOOST, DUAL SYNCHRONOUS BUCK CONTROLLER
Check for Samples: TPS43333-Q1
1
FEATURES
2
•
Qualified for Automotive Applications
Synchronization Range 150 kHz to 600 kHz
•
AEC-Q100 Test Guidance With the Following
Results:
•
•
Separate Enable Inputs (ENA, ENB)
Selectable Forced-Continuous Mode or
–
Device Temperature Grade 1: –40°C to
125°C Ambient Operating Temperature
Automatic Low-Power Mode at Light Loads
•
•
Sense Resistor or Inductor DCR Sensing
–
–
Device HBM ESD Classification Level H2
Device CDM ESD Classification Level C2
Out-of-Phase Switching Between Buck
Channels
•
•
•
Two Synchronous Buck Controllers
One Pre-Boost Controller
•
•
Peak Gate-Drive Current 1.5 A
Thermally Enhanced 38-Pin HTSSOP (DAP)
PowerPAD™ Package
Input Range up to 40 V, (Transients up to 60
V), Operation Down to 2 V When Boost is
Enabled
APPLICATIONS
•
Automotive Start-Stop, Infotainment,
Navigation Instrument Cluster Systems
•
Low-Power-Mode IQ: 30 µA (One Buck On),
35 µA (Two Bucks On)
•
Industrial and Automotive Multi-Rail DC Power
Distribution Systems and Electronic Control
Units
•
•
•
•
Low-Shutdown Current Ish < 4 µA
Buck Output Range 0.9 V to 11 V
Boost Output Selectable: 7 V, 10 V, or 11 V
Programmable Frequency and External
DESCRIPTION
The TPS43333-Q1 includes two current-mode synchronous buck controllers and a voltage-mode boost controller.
The device is ideal for use as a pre-regulator stage with low Iq requirements and for applications that must
survive supply drops due to cranking events. The integrated boost controller allows the device to operate down to
2 V at the input without seeing a drop on the buck-regulator output stages. At light loads, one can enable the
buck controllers to operate automatically in low-power mode, consuming just 30 µA of quiescent current.
The buck controllers have independent soft-start capability and power-good indicators. Current foldback in the
buck controllers and cycle-by-cycle current limitation in the boost controller provide external MOSFET protection.
The switching frequency is programmable over 150 kHz to 600 kHz or can synchronize to an external clock in
the same range.
VBAT
VBuckA
TPS43333-Q1
VBuckB
2 V
Figure 1. Typical Application Diagram
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
PowerPAD is a trademark of Texas Instruments.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2012–2013, Texas Instruments Incorporated