TMUX7308F
SCDS403A – FEBRUARY 2021 – REVISED OCTOBER 2021
TMUX730xF ±60-V Fault-Protected, 8:1 and Dual 4:1 Multiplexers with 1.8-V Logic
1 Features
3 Description
•
Wide supply range:
The TMUX7308F and TMUX7309F are modern
complementary metal-oxide semiconductor (CMOS)
analog multiplexers in 8:1 (single ended) and 4:1
(differential) configurations. The devices work well
with dual supplies (±5 V to ±22 V), a single supply
(8 V to 44 V), or asymmetric supplies. All control
inputs support logic levels from 1.8 V to 44 V, enabling
system level flexibility for controlling the multiplexer.
– Dual supply: ±5 V to ±22 V
– Single supply: 8 V to 44 V
Integrated fault protection:
•
– Overvoltage protection,
source to supplies or to Ddrain: ±85 V
– Overvoltage protection: ±60 V
– Powered-off protection: ±60 V
– Non-fault channels continue to operate with low
leakage currents
– Known state without digital inputs present
– Output clamped to the supply in overvoltage
condition
Latch-up immunity by device construction
Break-before-make switching action
Logic levels: 1.8 V to VDD
Industry standard TSSOP and
smaller WQFN packages
When no power supplies are present, the switch
channels remain in the OFF state regardless of
switch input conditions and logic control status. Under
normal operation conditions, if the analog input signal
level on any Sx pin exceeds the supply voltage (VDD
or VSS) by a threshold voltage (VT), the channel turns
OFF and the Sx pin becomes high impedance. When
the fault channel is selected, the drain pin (D or Dx) is
pulled to the supply (VDD or VSS) that was exceeded.
The device blocks fault voltage up to +60 V or –60
V relative to ground in both powered and powered-off
conditions.
•
•
•
•
2 Applications
•
•
•
•
•
•
•
Factory automation and control
Programmable logic controllers (PLC)
Analog input modules
Semiconductor test equipment
Battery test equipment
The low capacitance, low charge injection, and
integrated fault protection enable the TMUX7308F
and TMUX7309F devices to be used in front end
data acquisition applications where high performance
and high robustness are both critical. The devices are
available in a standard TSSOP package and smaller
WQFN package (ideal if PCB space is limited).
Servo drive control module
Data acquisition systems (DAQ)
VDD
VSS
VDD
VSS
Device Information(1)
SW
SW
SW
PART NUMBER
PACKAGE
TSSOP (16)
WQFN (16)
BODY SIZE (NOM)
5.00 mm × 4.40 mm
4.00 mm × 4.00 mm
S1
S2
S1A
DA
DB
TMUX7308F
TMUX7309F
SW
SW
S4A
S1B
D
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
SW
SW
S4B
S8
A1
A2
A3
EN
A1
A2
EN
Fault Detection/
Switch Driver/
Logic Decoder
Fault Detection/
Switch Driver/
Logic Decoder
TMUX7308F
TMUX7309F
Simplified Schematic
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. ADVANCE INFORMATION for preproduction products; subject to change
without notice.