5秒后页面跳转
TMUX730XF PDF预览

TMUX730XF

更新时间: 2024-11-09 02:50:59
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
54页 2618K
描述
TMUX730xF ±60-V Fault-Protected, 8:1 and Dual 4:1 Multiplexers with Latch-Up Immunity and 1.8-V Logic

TMUX730XF 数据手册

 浏览型号TMUX730XF的Datasheet PDF文件第2页浏览型号TMUX730XF的Datasheet PDF文件第3页浏览型号TMUX730XF的Datasheet PDF文件第4页浏览型号TMUX730XF的Datasheet PDF文件第5页浏览型号TMUX730XF的Datasheet PDF文件第6页浏览型号TMUX730XF的Datasheet PDF文件第7页 
TMUX7308F, TMUX7309F  
SCDS403B – FEBRUARY 2021 – REVISED DECEMBER 2021  
TMUX730xF ±60-V Fault-Protected, 8:1 and Dual 4:1 Multiplexers with Latch-Up  
Immunity and 1.8-V Logic  
1 Features  
3 Description  
Wide supply range:  
The TMUX7308F and TMUX7309F are modern  
complementary metal-oxide semiconductor (CMOS)  
analog multiplexers in 8:1 (single ended) and 4:1  
(differential) configurations. The devices work well  
with dual supplies (±5 V to ±22 V), a single supply (8  
V to 44 V), or asymmetric supplies (such as VDD = 12  
V, VSS = –5 V). The overvoltage protection is available  
in powered and powered-off conditions, making the  
TMUX7308F and TMUX7309F devices suitable for  
applications where power supply sequencing cannot  
be precisely controlled.  
– Dual supply: ±5 V to ±22 V  
– Single supply: 8 V to 44 V  
Integrated fault protection:  
Overvoltage protection, source to supplies or  
source to drain: ±85 V  
Overvoltage protection: ±60 V  
Powered-off protection: ±60 V  
Non-fault channels continue to operate  
Known state without logic inputs present  
Output clamped to the supply in overvoltage  
condition  
The device blocks fault voltage up to +60 V or –60  
V relative to ground in both powered and powered-off  
conditions. When no power supplies are present, the  
switch channels remain in the OFF state regardless of  
switch input conditions and logic control status. Under  
normal operation conditions, if the analog input signal  
level on any Sx pin exceeds the supply voltage (VDD  
or VSS) by a threshold voltage (VT), the channel turns  
OFF and the Sx pin becomes high impedance. When  
the fault channel is selected, the drain pin (D or Dx) is  
pulled to the supply (VDD or VSS) that was exceeded.  
Latch-up immune  
1.8-V Logic capable  
Fail-safe logic: up to 44 V independent of supply  
Integrated pull-down resistor on logic pins  
Break-before-make switching  
Industry standard TSSOP and  
smaller WQFN packages  
2 Applications  
Factory automation and control  
Programmable logic controllers (PLC)  
Analog input modules  
Semiconductor test equipment  
Battery test equipment  
The low capacitance, low charge injection, and  
integrated fault protection enables the TMUX7308F  
and TMUX7309F devices to be used in front end  
data acquisition applications where high performance  
and high robustness are both critical. The devices are  
available in a standard TSSOP package and smaller  
WQFN package (ideal if PCB space is limited).  
Servo drive control module  
Data acquisition systems (DAQ)  
VDD  
VSS  
VDD  
VSS  
SW  
SW  
SW  
Device Information(1)  
S1  
S2  
S1A  
DA  
DB  
PART NUMBER  
PACKAGE  
TSSOP (16)(2)  
WQFN (16)  
BODY SIZE (NOM)  
5.00 mm × 4.40 mm  
4.00 mm × 4.00 mm  
SW  
SW  
S4A  
S1B  
TMUX7308F  
TMUX7309F  
D
SW  
SW  
(1) For all available packages, see the orderable addendum at  
the end of the data sheet.  
S4B  
S8  
(2) Preview package for TMUX7309F.  
A0  
A1  
A2  
EN  
A0  
A1  
EN  
Fault Detection/  
Switch Driver/  
Logic Decoder  
Fault Detection/  
Switch Driver/  
Logic Decoder  
TMUX7308F  
TMUX7309F  
Functional Block Diagram  
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,  
intellectual property matters and other important disclaimers. PRODUCTION DATA.  
 
 
 
 

与TMUX730XF相关器件

型号 品牌 获取价格 描述 数据表
TMUX7348F TI

获取价格

具有故障阈值、闩锁效应抑制和 1.8V 逻辑电平的 ±60V 故障保护、8:1 多路复用器
TMUX7348FRTJR TI

获取价格

具有故障阈值、闩锁效应抑制和 1.8V 逻辑电平的 ±60V 故障保护、8:1 多路复用器
TMUX7349F TI

获取价格

具有故障阈值、闩锁效应抑制和 1.8V 逻辑电平的 ±60V 故障保护、双路 4:1 多路
TMUX7349FRTJR TI

获取价格

具有故障阈值、闩锁效应抑制和 1.8V 逻辑电平的 ±60V 故障保护、双路 4:1 多路
TMUX7411F TI

获取价格

TMUX741xF ±60 V Fault-Protected, 1:1 (SPST),
TMUX7411F_V01 TI

获取价格

TMUX741xF ±60 V Fault-Protected, 1:1 (SPST),
TMUX7411FRRPR TI

获取价格

具有 1.8V 逻辑电平的 ±60V 故障保护、1:1 (SPST) 四通道开关(四个低电
TMUX7412F TI

获取价格

TMUX741xF ±60 V Fault-Protected, 1:1 (SPST),
TMUX7412FRRPR TI

获取价格

TMUX741xF ±60 V Fault-Protected, 1:1 (SPST),
TMUX7413F TI

获取价格

TMUX741xF ±60 V Fault-Protected, 1:1 (SPST),