5秒后页面跳转
SY88403BLMG PDF预览

SY88403BLMG

更新时间: 2024-09-16 20:32:11
品牌 Logo 应用领域
美国微芯 - MICROCHIP 电信电信集成电路
页数 文件大小 规格书
12页 469K
描述
SPECIALTY TELECOM CIRCUIT, QCC16

SY88403BLMG 技术参数

是否Rohs认证: 符合生命周期:Active
包装说明:LEAD FREE, MLF-16Reach Compliance Code:compliant
HTS代码:8542.39.00.01Factory Lead Time:10 weeks
风险等级:1.46Is Samacsys:N
JESD-30 代码:S-XQCC-N16JESD-609代码:e4
长度:3 mm湿度敏感等级:2
功能数量:1端子数量:16
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:UNSPECIFIED封装代码:HVQCCN
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260认证状态:Not Qualified
座面最大高度:0.95 mm标称供电电压:3.3 V
表面贴装:YES电信集成电路类型:TELECOM CIRCUIT
温度等级:INDUSTRIAL端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:40
宽度:3 mmBase Number Matches:1

SY88403BLMG 数据手册

 浏览型号SY88403BLMG的Datasheet PDF文件第2页浏览型号SY88403BLMG的Datasheet PDF文件第3页浏览型号SY88403BLMG的Datasheet PDF文件第4页浏览型号SY88403BLMG的Datasheet PDF文件第5页浏览型号SY88403BLMG的Datasheet PDF文件第6页浏览型号SY88403BLMG的Datasheet PDF文件第7页 
SY88403BL  
3.3V 4.25Gbps CML Low-Power Limiting  
Post Amplifier with TTL LOS  
General Description  
Features  
The SY88403BL is a low-power limiting post amplifier  
optimized for copper applications. The device  
connects to typical transimpedance amplifiers (TIAs).  
The linear signal output from TIAs can contain  
significant amounts of noise and may vary in  
amplitude over time. The SY88403BL quantizes these  
signals and outputs typically 800mVPP voltage-limited  
waveforms.  
Multi-rate up to 4.25Gbps operation  
5mVPP input sensitivity  
Low noise 50Ω CML data outputs  
– 800mV output swing  
pp  
– 60ps edge rates  
– 1ps  
typ. random jitter  
RMS  
– 10ps typ. deterministic jitter  
PP  
The SY88403BL operates from a single +3.3V ±10%  
power supply, over an industrial temperature range of  
–40°C to +85°C. With its wide bandwidth and high  
gain, signals with data rates up to 4.25Gbps and as  
small as 5mVPP can be amplified to drive devices with  
CML inputs or AC-coupled PECL inputs.  
Chatter-free Loss-of-Signal (LOS) output  
– 3.5dB electrical hysteresis  
– OC-TTL output with internal 4.75kΩ pull-up  
resistor  
Programmable LOS sensitivity using single  
The SY88403BL incorporates a loss-of-signal (LOS)  
open-collector TTL output with internal 4.75kΩ pull-up  
resistor. A programmable loss-of-signal level set pin  
(LOSLVL) sets the sensitivity of the input amplitude  
detection. LOS asserts high if the input amplitude falls  
below the threshold set by LOSLVL and de-asserts  
low otherwise. LOS can be fed back to the enable bar  
(/EN) input to maintain output stability under a loss of  
signal condition. /EN de-asserts the true output signal  
without removing the input signal. Typically, 3.5dB  
LOS hysteresis is provided to prevent chattering.  
external resistor  
Internal 50Ω data input termination  
TTL /EN input allows feedback from LOS  
Wide operating range:  
– Single 3.3V ±10% power supply  
– Industrial temperature range: –40°C to +85°C  
Available in a 10-pin EPAD-MSOP and 16-pin QFN  
package  
Applications  
All support documentation can be found on Micrel’s  
web site at: www.micrel.com.  
1.062Gbps, 2.125Gbps and 4.25Gbps Fibre  
Channel  
Cable driver  
Typical Performance  
Small form factor (SFF) and small form factor  
pluggable (SFP) transceivers  
High-gain line driver and line receiver  
Markets  
Copper interconnect  
Datacom and telecom  
Storage area network (SAN)  
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com  
M9999-111808-F  
hbwhelp@micrel.com or (408) 955-1690  
November 2008  

与SY88403BLMG相关器件

型号 品牌 获取价格 描述 数据表
SY88403BLMGTR MICREL

获取价格

3.3V 4.25Gbps CML Low-Power Limiting Post Amplifier with TTL LOS
SY88422L MICREL

获取价格

4.25Gbps Laser Driver with Integrated Bias
SY88422L MICROCHIP

获取价格

The SY88422L is a single 3.3V supply, small form factor laser driver for telecom/datacom a
SY88422L_10 MICREL

获取价格

4.25Gbps Laser Driver with Integrated Bias
SY88422LMG MICREL

获取价格

4.25Gbps Laser Driver with Integrated Bias
SY88422LMGTR MICREL

获取价格

4.25Gbps Laser Driver with Integrated Bias
SY88432L MICREL

获取价格

4.25 Gbps Transceiver with Integrated FP/DFP Laser Diode Driver and Limiting Post Amplifie
SY88432L MICROCHIP

获取价格

The SY88432L is a low power transceiver device that integrates a 4.25Gbps FP/DFB laser dio
SY88432LMG MICREL

获取价格

4.25 Gbps Transceiver with Integrated FP/DFP Laser Diode Driver and Limiting Post Amplifie
SY88432LMGTR MICREL

获取价格

4.25 Gbps Transceiver with Integrated FP/DFP Laser Diode Driver and Limiting Post Amplifie