STPM32, STPM33, STPM34
Datasheet
ASSP for metering applications with up to four independent 24-bit 2nd order
sigma-delta ADCs, 4 MHz OSF and 2 embedded PGLNA
Features
•
Active power accuracy:
–
–
< 0.1% error over 5000 : 1 dynamic range
< 0.5% error over 10000 : 1 dynamic range
•
•
Exceeds 50-60 Hz EN 50470-x, IEC 62053-2x,
ANSI12.2x standard requirements for AC watt meters
Reactive power accuracy:
–
< 0.1% error over 2000 : 1 dynamic range
•
•
•
•
•
•
•
Dual mode apparent energy calculation
Product status link
STPM32
Instantaneous and averaged power
RMS and instantaneous voltage and current
STPM33
Under and overvoltage detection (sag and swell) and monitoring
Overcurrent detection and monitoring
STPM34
UART and SPI serial interface with programmable CRC polynomial verification
Programmable LED and interrupt outputs
Four independent 24-bit 2nd order sigma-delta ADCs
Two programmable gain chopper stabilized low-noise and low-offset amplifiers
Bandwidth 3.6 kHz at -3 dB
Product label
•
•
•
•
•
•
•
Vcc supply range 3.3 V ± 10%
Supply current Icc 4.3 mA (STPM32)
Input clock frequency 16 MHz, Xtal or external source
Twin precision voltage reference: 1.18 V with independent programmable TC,
30 ppm/°C typ.
•
•
•
Internal low drop regulator at 3 V (typ.)
QFN packages
Operating temperature from -40 °C to +105 °C
Description
The STPM3x is an ASSP family designed for high accuracy measurement of power
and energies in power line systems using the Rogowski coil, current transformer or
shunt current sensors. The STPM3x provides instantaneous voltage and current
waveforms and calculates RMS values of voltage and currents, active, reactive and
apparent power and energies. The STPM3x is a mixed signal IC family consisting of
an analog and a digital section. The analog section consists of up to two
programmable gain low-noise low-offset amplifiers and up to four 2nd order 24-bit
sigma-delta ADCs, two bandgap voltage references with independent temperature
compensation, a low drop voltage regulator and DC buffers. The digital section
consists of digital filtering stage, a hardwired DSP, DFE to the input and a serial
communication interface (UART or SPI). The STPM3x is fully configurable and allows
a fast digital system calibration in a single point over the entire current dynamic
range.
DS10272 - Rev 13 - September 2023
www.st.com
For further information contact your local STMicroelectronics sales office.