SGM6029
Ultra-Low Quiescent Current,
Synchronous Buck Converter
GENERAL DESCRIPTION
FEATURES
The SGM6029 family is a low voltage, efficient and
miniature synchronous Buck converter with ultra-low
quiescent current. Operating at high switching
frequency (4.0MHz, TYP), miniature inductors and
capacitors can be used to achieve minimal solution size.
The rated load current is from 0.6A to 1A depending on
the input voltage and operating frequency. For high
light-load efficiency, the operating mode can smoothly
and automatically change between power-save mode
and PWM.
● 1.95V to 5.5V Input Voltage Range
● 2.3μA (TYP) Quiescent Current
● Selectable Switching Frequency of 4.0MHz or
1.5MHz
● 0.4V Internal Reference Voltage
● 0.6A to 1A Peak Output Current
● 2% Output Voltage Regulation Accuracy Full
Temperature Range
● Programmable Light Load PSM or FPWM
● Simple Output Voltage Programming with
Integrated R2D Converter
The dual-role VSEL/MODE pin sets the output voltage
to one of the 16 preset values by sensing an external
resistor during startup using an integrated resistor to
digital (R2D) converter. After startup, this pin acts as
MODE input and applying a logic high on it will force the
device in the pulse width modulation (PWM) mode. This
will allow using the same part for a wide range of
voltage rails in different applications and offer a better
output accuracy compared to the conventional external
feedback resistor divider. In the forced-PWM (FPWM),
the device switches at 4.0MHz (A, B and C versions) or
1.5MHz (D and E versions). High switching frequency
reduces the output ripple, but at lighter loads, sacrifices
the efficiency a little bit.
● 16 Selectable + 1 Fixed Output Voltage Levels:
SGM6029A (4.0MHz): 0.4V to 0.775V
SGM6029B (4.0MHz): 0.8V to 1.55V
SGM6029C (4.0MHz): 1.8V to 3.3V
SGM6029D (1.5MHz): 0.4V to 0.775V
SGM6029E (1.5MHz): 0.8V to 1.55V
● Enable Pin with Auto Pull-Down during Startup
● Miniature 0201 Optimized Pinout
● Output Discharge Feature (When Disabled)
● 100% Duty Cycle Operation Capability
● Available in a Green WLCSP-0.74×1.09-6B Package
APPLICATIONS
Wearable Electronics
IoT Applications
The SGM6029 is available in a Green WLCSP-
0.74×1.09-6B package.
2 × 1.5V Battery Powered Applications
Smart Phones
TYPICAL APPLICATION
L1
0.47μH
L1
0.47μH
VIN
VOUT
0.8V to 1.55V
VIN
1.2V fixed VOUT
1.95V to 5.5V
1.95V to 5.5V
VIN
SW
VIN
EN
SW
SGM6029B
SGM6029B
VOS
VOS
CIN
COUT
10μF
CIN
4.7μF
COUT
PWM
VSEL/
MODE
VSEL/
MODE
4.7μF
10μF
PFM
EN
*
ON
ON
RVSEL
OFF
OFF
GND
GND
* 16 selectable VOUT
Figure 1. Typical Application Circuits
SG Micro Corp
www.sg-micro.com
SEPTEMBER2022–REV. A