Proximity Sensors
DIN Rail Mountable Single Channel
Interface Module
RDS-DIN1 Series
FEATURES
• DIN Rail mountable for ease
of installation in equipment
bungalows
• Built in test switch
• Available in current sink or
current source, with or
without time delay
• Sealed to IP67, NEMA 6P
• Short circuit protection
• Surge immunity
• Reverse polarity protection
• Radiated electric field
immunity
• LED output indicator
TYPICAL APPLICATIONS
• Used with 926FS30 Series
proximity sensors in
standalone applications
• Convert 2-wire DC N.C.
output to 3-wire DC N.O.
output
The RDS-DIN1 Series single channel interface modules are intended for
use with the 926FS30 Railwheel proximity sensors in standalone
applications. The DIN rail mountable modules convert the 2-wire DC
Normally Closed output of the railwheel sensor into a 3-wire DC Normally
Open output to interface with other equipment. Both NPN and PNP outputs,
with or without time delay, are available. The LED turns on when a target is
sensed by the railwheel proximity sensor. The single channel interface
modules have several important features: surge immunity means the RDS-
DIN1 Series can withstand 2000V 1/50µs 12 Ohm surges. Other features
include a built in test switch, short circuit immunity and reverse polarity
protection.
WARNING
PERSONAL INJURY
• DO NOT USE in applications
where product failure could
result in personal injury or
death.
• Improper installation of this
device can cause personal
injury. STRICTLY FOLLOW
the instructions included with
the product.
WARNING
MISUSE OF DOCUMENTATION
• The information presented in this product sheet is for reference only. DO
NOT USE this document as product installation information.
• Complete installation, operation and maintenance information is provided
in the instructions supplied with each product.
Failure to comply with these instructions could result in death or
serious injury.
MICRO SWITCH Sensing and Control