Datasheet
RAA210030
5V, 3A Step-Down DC/DC Mini Module with Integrated Inductor
The RAA210030 power module is a compact,
Features
single-channel, synchronous step-down, non-isolated
complete power supply, capable of delivering up to 3A
of continuous current. By operating from a single 2.7V
to 5.5V input power rail and integrating the controller,
gate driver, power inductor, and MOSFETs, the
RAA210030 is optimized for space constrained
applications.
▪ 3A complete power supply
• Integrates controller, gate driver, MOSFETs, and
inductor
▪ 2.7V to 5.5V input voltage range
▪ Adjustable output voltage
• As low as 0.6V with ±1.5% accuracy over line,
load, and temperature
Based on a peak current mode control scheme, the
RAA210030 provides fast transient response and
excellent loop stability. The output voltage can be set
as low as 0.6V, with setpoint accuracy better than
±1.5% over line, load, and temperature. The
operating frequency has a 2MHz default setting,
however it can also be set from 500kHz to 4MHz by
an external resistor. The external synchronization is
also supported with an external clock signal up to
4MHz. The RAA210030 supports 100% duty cycle
operation to minimize switching losses with typically
300mV dropout voltage. A dedicated enable pin and
power-good flag allow for easy system power rails
sequencing.
• Up to 95% efficiency
▪ Default 2MHz current mode control operation
• 500kHz to 4MHz resistor adjustable
• External synchronization up to 4MHz
• 100% duty cycle
▪ Dedicated enable pin and power-good flag
▪ Internal 1ms soft-start time
▪ Selectable PFM or FPWM mode
▪ Soft-stop output discharge
▪ UVLO, OCP, negative OCP, OVP, and OTP
• OCP/Short-Circuit Protection (SCP) hiccup
mode
The RAA210030 can be configured for pulsed
frequency modulation (PFM) or forced pulse width
modulation (FPWM) at light load. FPWM reduces
noise and RF interference, while PFM provides higher
efficiency by reducing switching losses at light loads.
▪ Compact RoHS compliant 3mm×3mm×1.08mm
(1.15mm Max) 10 lead dual flat embedded
laminate package
Applications
▪ Telecom, Industrial, optical, and medical equipment
An array of protection features, including input
Undervoltage Lockout (UVLO), Overcurrent
Protection (OCP), output Overvoltage Protection
(OVP), and Over-Temperature Protection (OTP),
ensures safe operations under abnormal operating
conditions.
▪ Point-of-load conversions
▪ MCU, MPU, DSP, and FPGA
The RAA210030 is available in a compact RoHS
compliant 3mm×3mm×1.08mm (1.15mm MAX) dual
flat embedded laminate package.
100
95
90
85
80
75
70
2.7V to 5.5V Input
1.8V 3A Output
RAA210030
VOUT
VIN
FS
22µF
22µFx2
100k
50k
10pF
EN
FB
SYNC
COMP
PGND
SGND
3.3V
5V
65
60
PGOOD
Power-Good
0.0
0.5
1.0
1.5
Load Current (A)
2.0
2.5
3.0
Figure 1. Typical Application Circuit
Figure 2. Efficiency VOUT = 1.8V, PWM Mode
R16DS0261EU0101 Rev.1.01
Jun 15, 2023
Page 1
© 2022-2023 Renesas Electronics