Datasheet
RAA212832
4.5V to 72V Input, 0.5A Buck Regulator with 2 Linear Regulator Outputs
The RAA212832 is a triple output regulator combining
a 4.5V to 72V input, 0.5A buck regulator with two LDO
Features
▪ Buck Converter:
outputs. The buck regulator has a fixed switching
frequency of 350kHz in Continuous Conduction mode
(CCM) and operates in Pulse Skipping mode at lighter
loads when it enters Discontinuous Conduction mode
(DCM). The two LDOs operate from a 12V (or lower)
input voltage. The LDOs are rated at 100mA and
50mA of output current. The buck regulator output is
fixed at either 6V or 12V, which is controlled by the
STBY pin. The LDOs can support an input voltage
range of 6V to 12V and the output voltages are fixed
at 3.3V and 5V. The IC provides a compact, highly
integrated power management solution. Its integrated
buck regulator and LDO outputs minimize system
component count.
• 4.5V to 72V input voltage
• Fixed output voltage 12V or 6V
• 500mA output load capability
• 0.6Ω high-side MOSEFT r
DS(ON)
• Fixed switching frequency 350kHz in CCM
operation
• Pulse skipping mode in DCM operation
• Standby function by STBY pin setting output
voltage
• High-side OCP, UVP, UVLO, OTP fault
protection
▪ 5V LDO Regulator:
The buck converter uses peak current mode control,
providing 500mA current for load and downstream
LDO regulators, while the LDOs provide 5V and 3.3V
regulated outputs for the system. The current-mode
buck converter provides a fast transient response and
cycle-by-cycle switching current limit. All output
voltages are fixed internally with few external
components required.
• 6V to 12V input voltage
• Fixed output voltage 5V
• 100mA output load capability
• Current limit foldback function
▪ 3.3V LDO Regulator:
• 4.5V to 12V input voltage
• Fixed output voltage 3.3V
• 50mA output load capability
• Current limit foldback function
▪ SOIC8-E package
At light load or no-load operation on the buck
regulator output, the RAA212832 operates in a Pulse
Skipping mode in DCM. When the output load is
increased, and the buck regulator enters CCM, the
controller operates at 350kHz.
Applications
▪ Electric-bike power management
The RAA212832 offers comprehensive protection
including UVLO, high-side overcurrent, output
undervoltage, and over-temperature protection.
▪ Motor driver control board power supply
The device is available in SOIC8-E package.
R1
VIN
LDO_VIN
VIN
CIN
GND
BST
SW
CBST
L1
VOUT
LDO_5V
LDO_3V3
D1
C5V
COUT
VSTBY
STBY
C3V3
Figure 1. Typical Application Diagram
R16DS0192EU0102 Rev.1.02
Mar 13, 2023
Page 1
© 2021-2023 Renesas Electronics