Datasheet
RAA220001
Synchronous Rectified Buck MOSFET Driver
The RAA220001 is a high frequency MOSFET driver
designed to drive upper and lower power N-channel
MOSFETs in a synchronous rectified buck converter
topology.
Features
• Dual MOSFET drives for synchronous rectified
bridge
• Advanced adaptive zero shoot-through protection
○ PHASE detection
In the RAA220001, the upper and lower gates are
both driven to an externally applied voltage that
provides the capability to optimize applications
involving trade-offs between gate charge and
conduction losses.
○ LGATE detection
○ Auto-zero of r
conduction offset effect
DS(ON)
• Low standby bias current
An advanced adaptive shoot-through protection is
integrated to prevent both the upper and lower
MOSFETs from conducting simultaneously and to
minimize dead time. The RAA220001 has a 10kΩ
integrated high-side gate-to-source resistor to prevent
self turn-on due to high input bus dV/dt.
• 36V internal bootstrap switcher
• Bootstrap capacitor overcharging prevention
• Integrated high-side gate-to-source resistor to
prevent from self turn-on due to high input bus dV/dt
• Pre-POR overvoltage protection for start-up and
shutdown
This driver also has an overvoltage protection feature
that is operational while V is below the POR
CC
threshold. The PHASE node is connected to the gate
of the low-side MOSFET (LGATE) through a 30kΩ
resistor, limiting the output voltage of the converter
close to the gate threshold of the low-side MOSFET.
This design is dependent on the current being
shunted, which provides some protection to the load
should the upper MOSFET(s) become shorted.
• Power rails undervoltage protection
• Expandable bottom copper pad for enhanced heat
sinking
• Dual flat no-lead (DFN) package
• Near chip-scale package footprint; improves PCB
efficiency and thinner in profile
• Pb-free (RoHS compliant)
Applications
• High light-load efficiency voltage regulators
• Core regulators for advanced microprocessors
• High current DC/DC converters
Related Literature
For a full list of related documents, visit our website:
• RAA220001 device page
VCC
BOOT
Pin 6
UGATE
10k
POR/
Control
Logic
+5V
40k
PHASE
Shoot-
PWM
30k
Through
Protection
VCC
Pin 7
Pins 6 and 7 must be
tied together
22.4k
LGATE
GND
Figure 1. Block Diagram
R16DS0005EU0100 Rev.1.00
Jul.11.19
Page 1 of 15