5秒后页面跳转
PN7150B0HN PDF预览

PN7150B0HN

更新时间: 2024-09-18 01:23:43
品牌 Logo 应用领域
恩智浦 - NXP /
页数 文件大小 规格书
55页 2149K
描述
High performance full NFC Forum-compliant controller with integrated firmware and NCI interface

PN7150B0HN 数据手册

 浏览型号PN7150B0HN的Datasheet PDF文件第2页浏览型号PN7150B0HN的Datasheet PDF文件第3页浏览型号PN7150B0HN的Datasheet PDF文件第4页浏览型号PN7150B0HN的Datasheet PDF文件第5页浏览型号PN7150B0HN的Datasheet PDF文件第6页浏览型号PN7150B0HN的Datasheet PDF文件第7页 
PN7150  
High performance full NFC Forum-compliant controller with  
integrated firmware and NCI interface  
Rev. 3.3 — 4 July 2016  
Product data sheet  
1. Introduction  
This document describes the functionality and electrical specification of the NFC  
Controller PN7150.  
Additional documents describing the product functionality further are available for  
design-in support. Refer to the references listed in this document to get access to the full  
for full documentation provided by NXP.  
2. General description  
Best plug´n play and high-performance full NFC solution PN7150 is a full NFC controller  
solution with integrated firmware and NCI interface designed for contactless  
communication at 13.56 MHz. It is compatible with NFC forum requirements.  
PN7150 is designed based on learnings from previous NXP NFC device generation. It is  
the ideal solution for rapidly integrating NFC technology in any application, especially  
those running O/S environment like Linux and Android, reducing Bill of Material (BOM)  
size and cost, thanks to:  
Full NFC forum compliancy (see Ref. 1) with small form factor antenna  
Embedded NFC firmware providing all NFC protocols as pre-integrated feature  
Direct connection to the main host or microcontroller, by I2C-bus physical and NCI  
protocol  
Ultra-low power consumption in polling loop mode  
Highly efficient integrated power management unit (PMU) allowing direct supply from  
a battery  
PN7150 embeds a new generation RF contactless front-end supporting various  
transmission modes according to NFCIP-1 and NFCIP-2, ISO/IEC14443, ISO/IEC 15693,  
MIFARE and FeliCa specifications. It embeds an ARM Cortex-M0 microcontroller core  
loaded with the integrated firmware supporting the NCI 1.0 host communication. It also  
allows to provide a higher output power by supplying the transmitter output stage from  
3.0 V to 4.75 V.  
The contactless front-end design brings a major performance step-up with on one hand a  
higher sensitivity and on the other hand the capability to work in active load modulation  
communication enabling the support of small antenna form factor.  
Supported transmission modes are listed in Figure 1. For contactless card functionality,  
the PN7150 can act autonomously if previously configured by the host in such a manner.  

与PN7150B0HN相关器件

型号 品牌 获取价格 描述 数据表
PN7150B0HN/C11002E NXP

获取价格

PN7150 - High performance full NFC Forum-compliant controller with integrated firmware and
PN7150B0HN/C11002Y NXP

获取价格

PN7150 - High performance full NFC Forum-compliant controller with integrated firmware and
PN7160A1EV NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7160A1HN NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7160B1EV NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7160B1HN NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7161A1EV NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7161A1HN NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7161B1EV NXP

获取价格

NFC Plug and Play Controller with Integrated Firmware and NCI Interface
PN7161B1HN NXP

获取价格

EMV L1 Compliant NFC Controller with NCI Interface Supporting EMV and NFC Forum Applicatio