CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS
Chip Type, High Reliability
CR series
High reliability, High voltage (to 100V).
Low ESR, High ripple current.
Long life of 4000 hours at 125°C.
SMD type : Lead free reflow soldering condition at
260°C peak complete correspondence.
Adapted to the RoHS directive (2011/65/EU).
Added ESR specification after the test at -40°C.
High Capacitance
CX
Long Life Assurance
C R
Specifications
Item
Performance Characteristics
Category Temperature Range
Rated Voltage Range
Rated Capacitance Range
Capacitance Tolerance
Tangent of loss angle (tan δ)
–55 to +125°C
6.3 to 100V
5.6 to 2700µF
± 20% at 120Hz, 20°C
Less than or equal to the specified value 120Hz, 20°C
at
(
1)
Less than or equal to the specified value 100kHz, 20°C
at
ESR
Leakage Current ( 2)
After 2 minutes' application of rated voltage, leakage current is not more than 0.03CV or 3( ), whichever is greater.
µA
Temperature Characteristics
(Max.Impedance Ratio)
Z+125°C / Z+20°C
Z–55°C / Z+20°C
1.25
1.25
(100kHz)
Capacitance change
Within ± 20% of initial capacitance value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Less than or equal to the initial specified value
The specifications listed at right shall be met when the
capacitors are restored to 20°C after D.C. bias plus rated
ripple current is applied for 4000 hours at 125°C, the peak
voltage shall not exceed the rated voltage.
tan δ
Endurance
(
1)
ESR
Leakage current ( 2)
The specifications listed at right shall be met when the capacitors are restored to 20°C after the rated voltage is applied for
1000 hours at 85°C, 85% RH.
Shelf Life
(
1)
Less than or equal to the specified value at 100kHz, -40°C
ESR after Endurance
Capacitance change
Within ± 20% of initial capacitance value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Less than or equal to the initial specified value
The specifications listed at right shall be met when the
capacitors are restored to 20°C after the rated voltage is
applied for 1000 hours at 85°C, 85% RH.
Damp Heat
tan δ
(
1)
ESR
(Steady State)
Leakage current ( 2)
After soldering the capacitor under the soldering conditions
prescribed here, the capacitor shall meet the specifications listed at
right, provided that it's temperature profile is measured at the
capacitor top and the terminal.
Pre-heating shall be done at 150 to 200°C and for 60 to 180 sec.
The duration for over +230°C temperature at capacitor surface shall
not exceed 60 seconds.
In the case of peak temp, less than 250°C, reflow soldering shall be
two times maximum.
Capacitance change
Within ± 10% of the initial capacitance value ( 3)
130% or less than the initial specified value
130% or less than the initial specified value
Less than or equal to the initial specified value
tan δ
Resistance to
Soldering Heat
(
1)
ESR
Leakage current ( 2)
In the case of peak temp, less than 260°C, reflow soldering shall be
once.
Measurement for solder temperature profile shall be made at the
capacitor top and the terminal.
Marking
Navy blue print on the case top
1 ESR should be measured at both of the terminal ends closest where the terminals protrude through the plastic platform.
2 Conditioning : If any doubt arises, measure the leakage current after the voltage treatment of applying DC rated voltage continuously to the capacitor for 120
minutes at 105°C.
3 Initial value : The value before test of examination of resistance to soldering.
Type numbering system (Example : 35V 150µF)
Positive
Dimensions
1
2
3
4
5
6
7
8
9 10 11 12 13 14
Plastic platform
0.3 MAX.
Capacitance
P C R 1 V 1 5 1 M C L 1 G S
Lot No.
C±0.2
Taping code
Size code
Configuration
Capacitance tolerance (±20%)
Rated capacitance
(
150µF
)
)
Rated voltage
(35V
+0.1
-0.4
L
Voltage (V:35V)
Series
Negative
Series name
Type
H
(mm)
×
×
×
×
×
×
×
×
×
Size φ5 6L φ6.3 6L φ6.3 8L φ8 7L φ8 10L φ8 12L φ10 8L φ10 10L φ10 12.7L
φ6.3 × 8L, φ8 × 7L, φ8 × 10L, φ10 × 10L :
The vibration structure-resistant product is also available upon request, please ask for detail.
φD
L
5.0
5.9
6.0
5.3
5.3
1.6
6.3
5.9
7.3
6.6
6.6
2.1
6.3
7.9
7.3
6.6
6.6
2.1
8.0
6.9
9.0
8.3
8.3
3.2
8.0
9.9
9.0
8.3
8.3
3.2
8.0
11.9
9.0
8.3
8.3
3.2
10.0
7.9
10.0
9.9
10.0
12.6
11.0
10.3
10.3
4.6
A
11.0
10.3
10.3
4.6
11.0
10.3
10.3
4.6
B
Voltage
V
C
E
6.3
j
10
A
16
C
20
D
25
E
35
V
50
H
63
J
80
K
100
2A
Code
H
0.5 to 0.8 0.5 to 0.8 0.5 to 0.8 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1
Dimension table in next page.
CAT.8100C
5秒后页面跳转
摩尔斯微电子在美国约书亚树国家公园测试 Wi-Fi HaLow
贸泽上架Tallysman TW5386智能GNSS天线
SL74HC10N：高性能三输入与非门解析
AIC1781A 电池充电控制器深度解析
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
