NCP383
Adjustable Current-Limiting
Power-Distribution
Switches
The NCP383 is a single input dual outputs power−distribution
switch designed for applications where heavy capacitive loads and
short−circuits are likely to be encountered, incorporating two very low
http://onsemi.com
MARKING
R , N−channel MOSFETs in a single package. Each channel of
DS(on)
the device limits the output current to a desired level by switching into
a constant−current mode when the output load exceeds the
current−limit threshold or a short circuit is present. The current−limit
threshold is externally fixed by a pull down resistor placed between
DIAGRAM
383
ALYWG
G
I
and GND. The power−switches rise and fall times are controlled to
UDFN10
CASE 517CC
lim
minimize current ringing during turn on/off.
An internal reverse−voltage detection comparator disables the
power−switch if the output voltage is higher than the input voltage to
protect devices on the input side of the switches.
A
L
= Assembly Location
= Wafer Lot
The /FLAGx logic output asserts low during over−current,
reverse−voltage or over temperature conditions. The switch is
controlled by a logic enable input active low.
Y
W
G
= Year
= Work Week
= Pb−Free Package
(*Note: Microdot may be in either location)
Features
• 2.7 V – 5.5 V Operating Range
• Current limit: Adjustable up to 2.8 A
PIN CONNECTIONS
•
7.5% Current Limit Accuracy at 2.8 A
1
2
10
9
GND
IN
/FLAG1
OUT1
OUT2
• Very fast Over−Current Detection Response: 2 ms (typ)
• 1 mA Maximum Standby Supply Current
• Under Voltage Lock−out (UVLO)
• Soft−Start Prevents Inrush Current
• Thermal Protection
IN
3
4
5
8
7
6
EN1
EN2
ILIM
/FLAG2
• Soft Turn−off
(Top View)
• Reverse Voltage Protection
Exposed pad must be soldered to PCB Ground plane.
• Enable Active Low
• mDFN 3x3 mm
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 9 of this data sheet.
• Compliance to IEC61000−4−2 (Level 4)
8.0 kV (Contact) − 15 kV (Air)
• UL Listed – File E343275
• CB − IEC60950−ED2 Certified
• CB – IEC60950−ED2−AM1 Certified
• This is a Pb−Free Device
Typical Applications
• Laptops
• USB Ports/Hubs
• TVs
©
Semiconductor Components Industries, LLC, 2012
1
Publication Order Number:
October, 2012 − Rev. 2
NCP383/D