NXP Semiconductors
Data Sheet: Technical Data
K22P80M120SF7
Rev. 7, 08/2016
Kinetis K22F 512KB Flash 80-Pin
MK22FN512CAP12R
MK22FN256CAP12R
MK22FN512CBP12R
WLCSP
120 MHz ARM® Cortex®-M4 Based Microcontroller with FPU
The Kinetis K22 product family members are optimized for
space-constrained, cost-sensitive applications requiring
lowpower, USB connectivity, and processing efficiency with a
floating point unit. These devices share the comprehensive
enablement and scalability of the Kinetis family.
This product offers:
• Run power consumption down to 156 μA/MHz and static
power consumption down to 3.8 μA, full state retention and
6 μS wakeup. Lowest static mode down to 140 nA.
• USB LS/FS OTG 2.0 with embedded 3.3 V, 120 mA LDO
voltage regulator. USB FS device crystal-less functionality.
80 WLCSP (AP)
4.13 x 3.56 x 0.564 mm 4.13 x 3.56 x 0.321 mm
Pitch 0.4 mm Pitch 0.4 mm
80 WLCSP (BP)
Performance
• 120 MHz ARM® Cortex®-M4 core with DSP
Analog modules
• Two 16-bit SAR ADCs (1.2 MS/s in 12bit mode)
• Up to two 12-bit DACs
instructions delivering 1.25 Dhrystone MIPS per MHz
• Two analog comparators (CMP) with 6-bit DAC
• Accurate internal voltage reference
Memories and memory interfaces
• 512 or 256 KB of embedded flash, and 128 KB of RAM
• FlexBus external bus interface
Communication interfaces
• Serial programming interface (EzPort)
• Preprogrammed Kinetis flashloader for one-time, in-
system factory programming
• USB LS/FS OTG 2.0 with on-chip transceiver and
USB LDO voltage regulator
• USB full-speed device crystal-less operation
• Two SPI modules
System peripherals
• Three UART modules and one low-power UART
• Two I2C: Support for up to 1 Mbps operation
• I2S module
• Flexible low-power modes, multiple wake up sources
• 16-channel DMA controller
• Independent external and software watchdog monitor
Timers
Clocks
• Two 8-ch general-purpose/PWM timers
• Two 2-ch general-purpose timers with quadrature
decoder functionality
• Periodic interrupt timers
• 16-bit low-power timer
• Two crystal oscillators: 32 kHz (RTC) and 32-40 kHz or
3-32 MHz
• Three internal oscillators: 32 kHz, 4 MHz, and 48 MHz
• Multi-purpose clock generator with PLL and FLL
• Real-time clock with independent power domain
• Programmable delay block
Security and integrity modules
• Hardware CRC module
• 128-bit unique identification (ID) number per chip
• Hardware random-number generator
• Flash access control to protect proprietary software
Operating Characteristics
• Voltage range (including flash writes): 1.71 to 3.6 V
• Temperature range (ambient): -40 to 85°C
Human-machine interface
• 52 general-purpose I/O (GPIO)
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.