MicroAmp MH-1 Housing
For Single MB Circuit Boards
F E A T U R E S
• Rapid prototyping
of 2-port circuits
• Compaꢀble with all
MB series boards
• SMA female connectors
• Ground terminal and
bias feed-through
• Cover and mounꢀng
hardware provided
The MicroAmp MH-1 housing will accommodate a single MB series circuit board to create a completely shielded 2-port circuit. Boards are
available for microwave amplifiers, filters, log detectors, frequency mulꢀpliers, dividers, and operaꢀonal amplifiers. Aꢁer assembling the
desired MB circuit board, simply drop the board into the housing cavity and screw the board in place using the supplied #1-72 socket head
cap screws. Then insert the SMA connectors into the side walls and secure them with the supplied #2-56 mounꢀng screws and solder the
center pins to the circuit board pads. The ground turret terminal and bias feed-through are then installed into the housing side wall and the
bias connecꢀon is soldered in place from the circuit board to the feed-through pin using a small gauge wire. A cover aꢂaches to the top of
the housing with #2-56 screws to complete the shielded assembly. The finished housing can be mounted to a baseplate using the corner
through holes.
1. Select Circuit Board
2. Assemble Board
3. Install into Housing
4. Add Connectors and Bias
M H - 1 K I T C O N T E N T S
1 ea. Housing
1 ea. Cover
2 ea. SMA female connectors
1 ea. Feed-through bias pin
1 ea. Ground turret terminal
6 ea. #2-56 x 3/16" pan head screws
6 ea. #1-72 x 1/8" socket head cap screws
OUTLINE DRAWING
For additional product information, please visit www.twinind.com
Contact information: 925-866-8946 (phone) 925-866-8937 (fax) Sales@twinind.com