Document Number: MC33932
Rev. 5.0, 10/2012
Freescale Semiconductor
Technical Data
5.0 A Throttle Control H-Bridge
33932
The 33932 is a monolithic H-Bridge Power IC in a robust thermally
enhanced package. The 33932 has two independent monolithic
H-Bridge Power ICs in the same package. They are designed primarily
for automotive electronic throttle control, but are applicable to any low
voltage DC servo motor control application within the current and
voltage limits stated in this specification.
THROTTLE CONTROL H-BRIDGE
Each H-Bridge in the 33932 is able to control inductive loads with
currents up to 5.0 A peak. RMS current capability is subject to the
degree of heatsinking provided to the device package. Internal peak-
current limiting (regulation) is activated at load currents above 6.5 A
±1.5 A. Output loads can be pulse-width modulated (PWM-ed) at
frequencies up to 11 kHz. A load current feedback feature provides a
proportional (0.24% of the load current) current output suitable for
monitoring by a microcontroller’s A/D input. A Status Flag output
reports under-voltage, over-current, and over-temperature fault
conditions.
VW SUFFIX (PB-FREE)
98ARH98330A
44-PIN HSOP
WITH PROTRUDING
HEAT SINK
EK SUFFIX (PB-FREE)
98ASA99334D
54-PIN SOICW-EP
Two independent inputs provide polarity control of two half-bridge
totem pole outputs. Two independent disable inputs are provided to
force the H-Bridge outputs to tri-state (high-impedance off state).
ORDERING INFORMATION
Features
Device
Temperature
• 8.0 to 28 V continuous operation (transient operation from 5.0 to
40 V)
(Add R2 Suffix for
Tape and Reel)
Package
Range (T )
A
• 235 m maximum RDS(ON) at 150 °C (each H-Bridge MOSFET)
• 3.0 and 5.0 V TTL / CMOS logic compatible inputs
• Output short-circuit protection (short to VPWR or GND)
• Over-current limiting (regulation) via internal constant-off-time
PWM
MC33932VW
MC33932EK
44 HSOP
-40 to 125 °C
54 SOICW-EP
• Temperature dependant current limit threshold reduction
• All inputs have an internal source/sink to define the default
(floating input) states
• Sleep mode with current draw < 50 µA (each half with inputs
floating or set to match default logic states)
V
V
PWR
DD
33932
SFA
FBA
VPWRA
CCPA
OUT1
MOTOR
IN1
IN2
D1
EN/D2
OUT2
PGNDA
AGNDA
V
PWR
MCU
IN3
IN4
D3
VPWRB
CCPB
OUT3
EN/D4
FBB
MOTOR
SFB
PGNDB
AGNDB
OUT4
V
DD
Figure 1. MC33932 Simplified Application Diagram
© Freescale Semiconductor, Inc., 2009-2012. All rights reserved.