Document Number: MC33932
Rev. 3.0, 1/2009
Freescale Semiconductor
Advance Information
5.0 A Throttle Control H-Bridge
33932
The 33932 is a monolithic H-Bridge Power IC in a robust thermally
enhanced package. The 33932 has two independent monolithic H-
Bridge Power ICs in the same package. They are designed primarily for
automotive electronic throttle control, but are applicable to any low-
voltage DC servo motor control application within the current and
voltage limits stated in this specification.
THROTTLE CONTROL H-BRIDGE
Each H-bridge in the 33932 is able to control inductive loads with
currents up to 5.0 A peak. RMS current capability is subject to the
degree of heatsinking provided to the device package. Internal peak-
current limiting (regulation) is activated at load currents above 6.5 A
±1.5 A. Output loads can be pulse width modulated (PWM-ed) at
frequencies up to 11 kHz. A load current feedback feature provides a
proportional (0.24% of the load current) current output suitable for
monitoring by a microcontroller’s A/D input. A Status Flag output
reports under-voltage, over-current, and over-temperature fault
conditions.
VW SUFFIX (PB-FREE)
98ARH98330A
44-PIN HSOP
WITH PROTRUDING HEAT SINK
Two independent inputs provide polarity control of two half-bridge
totem-pole outputs. Two independent disable inputs are provided to
force the H-bridge outputs to tri-state (high-impedance off-state).
ORDERING INFORMATION
Temperature
Device
Package
Range (T )
A
Features
MC33932VW/R2
-40°C to 125°C
44 HSOP
• 8.0 to 28 V continuous operation (transient operation from 5.0 to
40 V)
• 235 mΩ maximum RDS(ON) @ 150°C (each H-Bridge MOSFET)
• 3.0 V and 5.0 V TTL / CMOS logic compatible inputs
• Over-current limiting (regulation) via internal constant-off-time PWM
• Output short-circuit protection (short to VPWR or GND)
• Temperature-dependant current-limit threshold reduction
• All inputs have an internal source/sink to define the default (floating input) states
• Sleep Mode with current draw < 50 µA (each half with inputs floating or set to match default logic states)
V
V
PWR
DD
33932
SFA
FBA
IN1
VPWRA
CCPA
OUT1
IN2
D1
EN/D2
MOTOR
V
PWR
OUT2
PGNDA
AGNDA
MCU
IN3
IN4
D3
EN/D4
VPWRB
CCPB
OUT3
FBB
SFB
MOTOR
PGNDB
AGNDB
V
DD
OUT4
Figure 1. MC33932 Simplified Application Diagram
* This document contains certain information on a new product.
Specifications and information herein are subject to change without notice.
© Freescale Semiconductor, Inc., 2009. All rights reserved.