5秒后页面跳转
捷配首页

Datasheet > LPC2368FBD100
LPC2368FBD100 PDF预览

LPC2368FBD100

更新时间： 2024-10-26 04:19:51
品牌 Logo 应用领域
恩智浦 - NXP 闪存微控制器以太网
页数 文件大小 规格书
48页 1084K
描述
Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC

阅读下载

中文翻译

获取价格

LPC2368FBD100 技术参数

是否无铅： 不含铅是否Rohs认证： 符合
生命周期：Active零件包装代码：QFP
包装说明：14 X 14 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT407-1, LQFP-100针数：100
Reach Compliance Code：compliantECCN代码：EAR99
HTS代码：8542.31.00.01风险等级：5.31
具有ADC：YES地址总线宽度：
位大小：32CPU系列：ARM7
最大时钟频率：25 MHzDAC 通道：YES
DMA 通道：YES外部数据总线宽度：16
JESD-30 代码：S-PQFP-G100JESD-609代码：e3
长度：14 mm湿度敏感等级：3
I/O 线路数量：70端子数量：100
最高工作温度：85 °C最低工作温度：-40 °C
PWM 通道：YES封装主体材料：PLASTIC/EPOXY
封装代码：LFQFP封装等效代码：QFP100,.63SQ,20
封装形状：SQUARE封装形式：FLATPACK, LOW PROFILE, FINE PITCH
峰值回流温度（摄氏度）：260电源：3.3 V
认证状态：Not QualifiedRAM（字节）：59392
ROM（单词）：524288ROM可编程性：FLASH
座面最大高度：1.6 mm速度：72 MHz
子类别：Microcontrollers最大压摆率：100 mA
最大供电电压：3.6 V最小供电电压：3 V
标称供电电压：3.3 V表面贴装：YES
技术：CMOS温度等级：INDUSTRIAL
端子面层：Tin (Sn)端子形式：GULL WING
端子节距：0.5 mm端子位置：QUAD
处于峰值回流温度下的最长时间：30宽度：14 mm
uPs/uCs/外围集成电路类型：MICROCONTROLLER, RISCBase Number Matches：1

LPC2368FBD100 数据手册

 浏览型号LPC2368FBD100的Datasheet PDF文件第2页浏览型号LPC2368FBD100的Datasheet PDF文件第3页浏览型号LPC2368FBD100的Datasheet PDF文件第4页浏览型号LPC2368FBD100的Datasheet PDF文件第5页浏览型号LPC2368FBD100的Datasheet PDF文件第6页浏览型号LPC2368FBD100的Datasheet PDF文件第7页 
LPC2364/66/68  
Single-chip 16-bit/32-bit microcontrollers; up to 512 kB flash  
with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC  
Rev. 01 — 22 September 2006  
Preliminary data sheet  
1. General description  
The LPC2364/66/68 microcontrollers are based on a 16-bit/32-bit ARM7TDMI-S CPU with  
real-time emulation that combines the microcontroller with up to 512 kB of embedded  
high-speed flash memory. A 128-bit wide memory interface and a unique accelerator  
architecture enable 32-bit code execution at the maximum clock rate. For critical  
performance in interrupt service routines and DSP algorithms, this increases performance  
up to 30 % over Thumb mode. For critical code size applications, the alternative 16-bit  
Thumb mode reduces code by more than 30 % with minimal performance penalty.  
The LPC2364/66/68 are ideal for multi-purpose serial communication applications. They  
incorporate a 10/100 Ethernet Media Access Controller (MAC), USB full speed device  
with 4 kB Endpoint RAM, four UARTs, two CAN channels, an SPI interface, two  
Synchronous Serial Ports (SSP), three I2C interfaces, and an I2S interface. This blend of  
serial communications interfaces combined with an on-chip 4 MHz internal oscillator,  
SRAM of up to 32 kB, 16 kB SRAM for Ethernet, 8 kB SRAM for USB and general  
purpose use, together with 2 kB battery powered SRAM make these devices very well  
suited for communication gateways and protocol converters. Various 32-bit timers, an  
improved 10-bit ADC, 10-bit DAC, one PWM unit, a CAN control unit, and up to 70 fast  
GPIO lines with up to 12 edge or level sensitive external interrupt pins make these  
microcontrollers particularly suitable for industrial control and medical systems.  
2. Features  
„ ARM7TDMI-S processor, running at up to 72 MHz.  
„ Up to 512 kB on-chip Flash Program Memory with In-System Programming (ISP) and  
In-Application Programming (IAP) capabilities. Flash program memory is on the ARM  
local bus for high performance CPU access.  
„ 8/32 kB of SRAM on the ARM local bus for high performance CPU access.  
„ 16 kB SRAM for Ethernet interface. Can also be used as general purpose SRAM.  
„ 8 kB SRAM for general purpose DMA use also accessible by the USB.  
„ Dual AHB system that provides for simultaneous Ethernet DMA, USB DMA, and  
program execution from on-chip Flash with no contention between those functions. A  
bus bridge allows the Ethernet DMA to access the other AHB subsystem.  
„ Advanced Vectored Interrupt Controller, supporting up to 32 vectored interrupts.  
„ General Purpose AHB DMA controller (GPDMA) that can be used with the SSP serial  
interfaces, the I2S port, and the SD/MMC card port, as well as for memory-to-memory  
transfers.  
„ Serial Interfaces:  
1234567...48

中文翻译

下载PDF

LPC2368FBD100 替代型号

型号 品牌 替代类型 描述 数据表
LPC1778FBD144 NXP

功能相似

 32-bit ARM Cortex-M3 microcontroller; up to 512 kB flash and 96 kB SRAM; USB Device/Host/O

与LPC2368FBD100相关器件

型号 品牌 获取价格 描述 数据表
LPC2368FBD100K NXP

获取价格

 		RISC Microcontroller
LPC2368FBD100-S NXP

获取价格

 		IC,MICROCONTROLLER,32-BIT,ARM7 CPU,QFP,100PIN,PLASTIC
LPC2368FET100 NXP

获取价格

 		Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0
LPC2368FET100,551 NXP

获取价格

 		LPC2368FET100 - ARM7 with 512 kB flash, 58 kB SRAM, Ethernet, USB 2.0 Device, CAN, SD/MMC,
LPC2368FET100-T NXP

获取价格

 		IC,MICROCONTROLLER,32-BIT,ARM7 CPU,BGA,100PIN,PLASTIC
LPC2368FET100Z NXP

获取价格

 		LPC2368FET100 - ARM7 with 512 kB flash, 58 kB SRAM, Ethernet, USB 2.0 Device, CAN, SD/MMC,
LPC2377 NXP

获取价格

 		Single-chip 16-bit/32-bit microcontroller; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, C
LPC2377_10 NXP

获取价格

 		Single-chip 16-bit/32-bit microcontrollers; 512 kB flash withISP/IAP, Ethernet, USB 2.0, C
LPC2377FBD144 NXP

获取价格

 		Single-chip 16-bit/32-bit microcontroller; 512 kB flash with ISP/IAP, Ethernet, USB 2.0, C
LPC2377FBD144,551 NXP

获取价格

 		LPC2377FBD144 - ARM7 with 512KB flash, 58 KB SRAM, Ethernet, and 10-bit ADC QFP 144-Pin

与LPC2368FBD100相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证