5秒后页面跳转
LMK04001BISQ/NOPB PDF预览

LMK04001BISQ/NOPB

更新时间: 2024-11-15 11:11:11
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
66页 1150K
描述
具有 1430MHz 至 1570MHz VCO 的低噪声抖动消除器:3 路输出用于 2VPEC/LVPEC+4 路输出用于 LVCMOS | RHS | 48 | -40 to 85

LMK04001BISQ/NOPB 数据手册

 浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第2页浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第3页浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第4页浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第5页浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第6页浏览型号LMK04001BISQ/NOPB的Datasheet PDF文件第7页 
LMK04000, LMK04001, LMK04002, LMK04010  
LMK04011, LMK04031, LMK04033  
www.ti.com  
SNOSAZ8J SEPTEMBER 2008REVISED SEPTEMBER 2011  
LMK04000 Family Low-Noise Clock Jitter Cleaner with Cascaded PLLs  
Check for Samples: LMK04000, LMK04001, LMK04002, LMK04010, LMK04011, LMK04031, LMK04033  
1
FEATURES  
23  
Cascaded PLLatinum™ PLL Architecture  
Support Clock Rates up to 1080 MHz  
PLL1  
Default Clock Output (CLKout2) at power up  
Phase Detector Rate of up to 40 MHz  
Five Dedicated Channel Divider and Delay  
Blocks  
Integrated Low-Noise Crystal Oscillator  
Circuit  
Pin Compatible Family of Clocking Devices  
Industrial Temperature Range: -40 to 85 °C  
3.15 V to 3.45 V Operation  
Dual Redundant Input Reference Clock  
with LOS  
PLL2  
Package: 48 Pin WQFN (7.0 x 7.0 x 0.8 mm)  
Normalized [1 Hz] PLL Noise Floor of -  
224 dBc/Hz  
APPLICATIONS  
Phase Detector Rate up to 100 MHz  
Input Frequency-Doubler  
Integrated Low-Noise VCO  
Data Converter Clocking  
Wireless Infrastructure  
Networking, SONET/SDH, DSLAM  
Medical  
Ultra-Low RMS Jitter Performance  
150 fs RMS Jitter (12 kHz – 20 MHz)  
200 fs RMS Jitter (100 Hz – 20 MHz)  
Military / Aerospace  
Test and Measurement  
Video  
LVPECL/2VPECL, LVDS, and LVCMOS outputs  
DESCRIPTION  
The LMK04000 family of precision clock conditioners provides low-noise jitter cleaning, clock multiplication and  
distribution without the need for high-performance voltage controlled crystal oscillators (VCXO) module. Using a  
cascaded PLLatinum™ architecture combined with an external crystal and varactor diode, the LMK04000 family  
provides sub-200 femtosecond (fs) root mean square (RMS) jitter performance.  
The cascaded architecture consists of two high-performance phase-locked loops (PLL), a low-noise crystal  
oscillator circuit, and a high-performance voltage controlled oscillator (VCO). The first PLL (PLL1) provides a low-  
noise jitter cleaner function while the second PLL (PLL2) performs the clock generation. PLL1 can be configured  
to either work with an external VCXO module or use the integrated crystal oscillator with an external crystal and  
a varactor diode. When used with a very narrow loop bandwidth, PLL1 uses the superior close-in phase noise  
(offsets below 50 kHz) of the VCXO module or the crystal to clean the input clock. The output of PLL1 is used as  
the clean input reference to PLL2 where it locks the integrated VCO. The loop bandwidth of PLL2 can be  
optimized to clean the far-out phase noise (offsets above 50 kHz) where the integrated VCO outperforms the  
VCXO module or crystal used in PLL1.  
The LMK04000 family features dual redundant inputs, five differential outputs, and an optional default-clock upon  
power up. The input block is equipped with loss of signal detection and automatic or manual selection of the  
reference clock. Each clock output consists of a programmable divider, a phase synchronization circuit, a  
programmable delay, and an LVDS, LVPECL, or LVCMOS output buffer. The default startup clock is available on  
CLKout2 and it can be used to provide an initial clock for the field-programmable gate array (FPGA) or  
microcontroller that programs the jitter cleaner during the system power up sequence.  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
2
3
PLLatinum is a trademark of Texas Instruments.  
All other trademarks are the property of their respective owners.  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  
Copyright © 2008–2011, Texas Instruments Incorporated  

LMK04001BISQ/NOPB 替代型号

型号 品牌 替代类型 描述 数据表
LMK04001BISQE/NOPB TI

类似代替

具有 1430MHz 至 1570MHz VCO 的低噪声抖动消除器:3 路输出用于 2V

与LMK04001BISQ/NOPB相关器件

型号 品牌 获取价格 描述 数据表
LMK04001BISQE NSC

获取价格

Low-Noise Clock Jitter Cleaner with Cascaded PLLs
LMK04001BISQE/NOPB TI

获取价格

具有 1430MHz 至 1570MHz VCO 的低噪声抖动消除器:3 路输出用于 2V
LMK04001BISQX NSC

获取价格

Low-Noise Clock Jitter Cleaner with Cascaded PLLs
LMK04001BISQX/NOPB TI

获取价格

具有 1430MHz 至 1570MHz VCO 的低噪声抖动消除器:3 路输出用于 2V
LMK04002 TI

获取价格

具有 1600MHz 至 1750MHz VCO 的低噪声抖动消除器:3 路输出用于 2V
LMK04002BISQ NSC

获取价格

Low-Noise Clock Jitter Cleaner with Cascaded PLLs
LMK04002BISQ/NOPB TI

获取价格

具有 1600MHz 至 1750MHz VCO 的低噪声抖动消除器:3 路输出用于 2V
LMK04002BISQE NSC

获取价格

Low-Noise Clock Jitter Cleaner with Cascaded PLLs
LMK04002BISQE/NOPB TI

获取价格

具有 1600MHz 至 1750MHz VCO 的低噪声抖动消除器:3 路输出用于 2V
LMK04002BISQX NSC

获取价格

Low-Noise Clock Jitter Cleaner with Cascaded PLLs