AC Electrical Characteristics
The following specifications apply for V+ = 5V, V− = 0V, VCM = 1.5V, VO = 2.5V, and RL = 1M unless other otherwise noted.
Boldface limits apply at the temperature extremes; all other limits TJ = 25˚C.
LMC6022I
Typical
(Note 5)
Symbol
SR
Parameter
Conditions
(Note 8)
Limit
(Note 6)
0.05
Units
Slew Rate
0.11
V/µs
min
MHz
Deg
dB
0.03
GBW
φM
Gain-Bandwidth Product
Phase Margin
0.35
50
GM
Gain Margin
17
Amp-to-Amp Isolation
Input-Referred Voltage Noise
(Note 9)
130
42
dB
en
in
F = 1 kHz
Input-Referred Current Noise
F = 1 kHz
0.0002
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to component may occur. Operating Ratings indicate conditions for which the device is in-
tended to be functional, but do not guarantee specific performance limits. For guaranteed specifications and test conditions, see the Electrical Characteristics. The
guaranteed specifications apply only for the test conditions listed.
Note 2: Applies to both single-supply and split-supply operation. Continuous short circuit operation at elevated ambient temperature and/or multiple Op Amp shorts
±
can result in exceeding the maximum allowed junction temperature of 150˚C. Output currents in excess of 30 mA over long term may adversely affect reliability.
Note 3: The maximum power dissipation is a function of T , θ and T . The maximum allowable power dissipation at any ambient temperature is P = (T
J(max)
J(max) JA
A
D
− T )/θ
.
JA
A
Note 4: Human body model, 100 pF discharged through a 1.5 kΩ resistor.
Note 5: Typical values represent the most likely parametric norm.
Note 6: All limits are guaranteed by testing or correlation.
+
Note 7: V = 15V, V
= 7.5V, and R connected to 7.5V. For Sourcing tests, 7.5V ≤ V ≤ 11.5V. For Sinking tests, 2.5V ≤ V ≤ 7.5V.
L O O
CM
+
Note 8: V = 15V. Connected as Voltage Follower with 10V step input. Number specified is the slower of the positive and negative slew rates.
+
Note 9: Input referred. V = 15V and R = 100 kΩ connected to 7.5V. Each amp excited in turn with 1 kHz to produce V = 13 V
.
L
O
PP
Note 10: For operating at elevated temperatures the device must be derated based on the thermal resistance θ with P = (T −T )/θ .
JA
JA
D
J
A
Note 11: All numbers apply for packages soldered directly into a PC board.
+
+
Note 12: Do not connect output to V when V is greater than 13V or reliability may be adversely affected.
www.national.com
4
This Material Copyrighted by Its Respective Manufacturer