High Power Li-Ion Charger W/I-Path Management
ISL9230
Features
The ISL9230 is a fully integrated high input voltage single-cell
Li-ion battery charger with power path management function.
This charger performs the CC/CV charge function required by
Li-ion batteries. The charger can withstand an input voltage up to
26V but is disabled when the input voltage exceeds 6.6V OVP
threshold. The input current limit and charge current are
programmable with external resistors. When the battery voltage
is lower than 3.0V, the charger preconditions the battery with
10% of the programmed charge current. When the charge
current reduces to the end-of-charge (EOC) current level during
the CV charge phase, the EOC indicator (CHG) will toggle to a
logic high to indicate the end-of-charge condition.
• Complete Charger for Single-Cell Li-ion/Polymer Batteries
• Current Path Management Optimize for Charge and System
Currents
• Intelligent Timeout Interval Based on Actual Charge Current
• 1% Charger Output Voltage Accuracy
• Programmable Input Current Limit
• Programmable Charge Current
• NTC Thermistor Input
• Complies with USB Charger
• Charge Current Thermal Foldback for Thermal Protection
• Trickle Charge for Fully Discharged Batteries
• 26V Maximum Voltage at VIN Pin
The ISL9230 uses separate power paths to supply the system
load and the battery. This feature allows the system to
immediately operate with a completely discharged battery. This
feature also allows the charge to terminate when the battery is
full while continuing to supply the system power from the input
source, thus minimizing unnecessary charge/discharge cycles
and prolonging the battery life.
• Power Presence and Charge Indications
• Ambient Temperature Range: -40°C to +85°C
• 16 Ld 3x3 TQFN Package
Two indication pins (PG and CHG) allow simple interface to a
microprocessor or LEDs.
• Pb-Free (RoHS Compliant)
Applications
• Mobile Phones
• Blue-Tooth Devices
• PDAs
• MP3 Players
• Stand-Alone Chargers
• Other Handheld Devices
INPUT
TO SYS
C3
PART
DESCRIPTION
4.7µF X5R ceramic capacitor
1µF X5R ceramic capacitor
4.7µF X5R ceramic capacitor
(Application specific)
VOUT
VBAT
VIN
C1
C
1
2
ISL9230
C
R2
C2
R1
CONT
}
FROM
µP
C3
CHGEN
IREF
R
R
IREF
D1
PG
CHG
NTC
(Application specific)
R
IREF
TIME
ILIM
R
(Application specific)
ILIM
R
ILIM
BATT
TIME
R , R 300 to 1kΩ, 5% resistor
T
1
2
AC/USB
MODE
RTIME
FROM µP
}
D , D LEDs for indication
GND
1
2
FIGURE 1. TYPICAL APPLICATION CIRCUIT
July 22, 2011
FN7642.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas Inc. 2011. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1