ISL54222
®
Data Sheet
May 27, 2009
FN6835.1
High-Speed USB 2.0 (480Mbps)
Multiplexer
Features
• High-Speed (480Mbps) and Full-Speed (12Mbps)
Signaling Capability per USB 2.0
The Intersil ISL54222 is a single supply dual 2:1 multiplexer
that can operate from a single 1.8V to 3.3V supply. It contains
two SPDT (Single Pole/Double Throw) switches configured as
a DPDT. The part was designed for switching or routing of
USB High-Speed signals and/or USB Full-speed signals in
portable battery powered products.
• 1.8V Logic Compatible
• Enable Pin to Open all Switches
• Power OFF Protection
• D-/D+ Pins are Overvoltage Tolerant to 5.5V
• -3dB Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . 782MHz
• Low ON Capacitance. . . . . . . . . . . . . . . . . . . . . . . . 6.5pF
• Low ON-Resistance. . . . . . . . . . . . . . . . . . . . . . . . . . 5.5Ω
The 5.5Ω switches can swing rail-to-rail and were specifically
designed to pass USB full speed data signals that range from
0V to 3.3V and USB high speed data signals that range from
0V to 400mV with a single supply as low as 1.8V. They have
high bandwidth and low capacitance to pass USB high speed
data signals with minimal distortion.
• Single Supply Operation (V ) . . . . . . . . . . . . 1.8V to 3.3V
DD
• Available in µTQFN, TDFN, and MSOP Packages
• Pb-Free (RoHS Compliant)
The part can be used in Personal Media Players and other
portable battery powered devices that need to route USB
high-speed signals and/or full-speed signals to different
transceiver sections of the device while connected to a single
USB host (computer).
• Compliant with USB 2.0 Short Circuit and Overvoltage
Requirements Without Additional External Components
Applications
The digital logic inputs are 1.8V logic compatible when
operated with a 1.8V to 3.3V supply. The ISL54222 has an
output enable pin to open all the switches. It can be used to
facilitate proper bus disconnect and connection when
switching between the USB sources.
• MP3 and other Personal Media Players
• Cellular/Mobile Phones
• PDA’s
The ISL54222 is available in 10 Ld 1.8mmx1.4mm µTQFN,
10 Ld TDFN and 10 Ld MSOP packages. It operates over a
temperature range of -40 to +85°C.
• Digital Cameras and Camcorders
• USB Switching
Application Block Diagram
µCONTROLLER
V
DD
ISL54222
OE
SEL
USB
HIGH-SPEED
OR
LOGIC CIRCUITRY
VBUS
D-
FULL-SPEED
TRANSCEIVER
#1
HSD1-
HSD1+
D-
USB
HIGH_SPEED
OR
FULL-SPEED
TRANSCEIVER
#2
D+
HSD2-
HSD2+
D+
GND
GND
PORTABLE MEDIA DEVICE
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2009. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.