Application Note 1565
ISL281X7MSOPEVAL1Z Evaluation Board User’s Guide
tied together to the power supply negative terminal. For
split supplies, +V and -V terminals connect to their
The ISL281X7MSOPEVAL1Z evaluation board is a design
respective power supply terminals. De-coupling
Introduction
platform containing all the circuitry needed to
characterize critical performance parameters of the
capacitors C2 and C4 connect close to their respective
supplies, while two additional capacitors, C1 and C5, are
ISL281X7 operational amplifiers in MSOP-8 package,
connected close to the part to filter out high frequency
using a variety of user defined test circuits.
noise. Anti-reverse diodes D1 and D2 protect the circuit
in the case of accidental polarity reversal.
The ISL281X7 operational amplifiers feature low bias
current, low noise, and low offset and temperature drift.
V-
V+
VREF
Reference Documents
• ISL28107 Data Sheet, FN6631
• ISL28117 Data Sheet, FN6632
• ISL28127 Data Sheet, FN6633
C2
C4
4.7µF
D1
4.7µF
D2
Evaluation Board Key Features
S1AB
S1AB
The ISL281X7MSOPEVAL1Z is designed to enable the IC
to operate from a single supply, +4.5VDC to +40VDC or
from split supplies, ±2.25VDC to ±20V. The board is
configured for a single op amp connected for differential
input with a closed loop gain of 10. A single external
reference voltage (VREF) pin and provisions for a
user-selectable voltage divider-filter are included.
FIGURE 1. POWER SUPPLY CIRCUIT
Amplifier Configuration (Figure 2)
The schematic of 1/2 of the op amp with the components
supplied is shown in Figure 2. The circuit implements a
differential input amp with a closed loop gain of 10. The
circuit can operate from a single supply or from dual
supplies. The VREF pin must be connected to ground to
establish a ground referenced input for dual supply
operation, or can be externally set to any reference level for
single supply operation. VREF should not be left floating.
Power Supplies (Figure 1)
External power connections are made through the +V, -V,
VREF and Ground connections on the evaluation board.
For single supply operation, the -V and Ground pins are
RF
ISL281X7
100kΩ
IN -
VP
RIN-
IN-
-
IN-
0Ω
V+
V-
10k
Ω
VOUT
RIN+
IN+
+
IN+
10kΩ
VM
IN +
VREF
RL
VCM
RREF+
DNP
100kΩ
GND
VREF
FIGURE 2. BASIC AMPLIFIER CONFIGURATION
May 25, 2010
AN1565.0
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2010. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.