5秒后页面跳转
捷配首页

Datasheet > 驱动程序和接口 > 显示驱动器> HV826X
HV826X PDF预览

HV826X

更新时间： 2024-11-20 22:33:43
品牌 Logo 应用领域
超科 - SUPERTEX 驱动器高压
页数 文件大小 规格书
6页 336K
描述
High Voltage EL Lamp Driver

阅读下载

中文翻译

获取价格

HV826X 技术参数

是否Rohs认证： 不符合生命周期：Obsolete
零件包装代码：DIE包装说明：DIE,
Reach Compliance Code：unknown风险等级：5.91
接口集成电路类型：EL DISPLAY DRIVERJESD-30 代码：X-XUUC-N
JESD-609代码：e0功能数量：1
最高工作温度：85 °C最低工作温度：-25 °C
封装主体材料：UNSPECIFIED封装代码：DIE
封装形状：UNSPECIFIED封装形式：UNCASED CHIP
峰值回流温度（摄氏度）：NOT SPECIFIED认证状态：Not Qualified
最大供电电压：3.5 V最小供电电压：1.8 V
表面贴装：YES技术：CMOS
温度等级：OTHER端子面层：TIN LEAD
端子形式：NO LEAD端子位置：UPPER
处于峰值回流温度下的最长时间：NOT SPECIFIEDBase Number Matches：1

HV826X 数据手册

 浏览型号HV826X的Datasheet PDF文件第2页浏览型号HV826X的Datasheet PDF文件第3页浏览型号HV826X的Datasheet PDF文件第4页浏览型号HV826X的Datasheet PDF文件第5页浏览型号HV826X的Datasheet PDF文件第6页 
HV826  
High Voltage EL Lamp Driver  
Ordering Information  
Package Options  
SO-8  
Device  
MSOP-8  
Die  
HV826  
HV826MG*  
HV826LG  
HV826X  
* Product supplied on 2500 piece carrier tape reels.  
Features  
General Description  
❏ 1.8V to 3.5V operating supply voltage  
The Supertex HV826 is a high voltage driver designed for driving  
EL lamps. The input supply voltage range is from 1.8V to 3.5V.  
The device uses a single inductor and a minimum number of  
passive components.The nominal regulated output voltage that  
is applied to the EL lamp is 80V. The chip can be enabled/  
disabled by connecting the resistor on RSW-OSC to VDD/ground.  
❏ DC to AC conversion  
❏ Adjustable output frequency  
❏ Adjustable switch frequency  
❏ Output voltage regulation  
❏ Enable/disable function  
The HV826 has two internal oscillators, a switching MOSFET,  
and a high voltage EL lamp driver. The frequency for the  
switching MOSFET is set by an external resistor connected  
between the RSW-osc pin and the supply pin VDD. The EL lamp  
driver frequency is set by an external resistor connected be-  
tween REL-osc pin and the VDD pin. An external inductor is  
connected between the LX and VDD pins. A 0.01-0.1µF capacitor  
is connected between CS and ground.The EL lamp is connected  
between VA and VB.  
Applications  
❏ Mobile cellular phones  
❏ Pagers  
The switching MOSFET charges the external inductor and  
discharges it into the capacitor at CS.The voltage at CS will start  
to increase. Once the voltage at CS reaches a nominal value of  
80V, the switching MOSFET is turned OFF to conserve power.  
The outputs VA and VB are configured as an H bridge and are  
switching in opposite states to achieve 160V peak-to-peak  
across the EL lamp.  
❏ Portable Transceivers  
❏ Remote Control Units  
❏ Calculators  
Pin Configuration  
Absolute Maximum Ratings*  
Supply Voltage, VDD  
-0.5V to +4.5V  
Output Voltage, VCs  
-0.5V to +100V  
-25° to +85°C  
-65°C to +150°C  
250mW  
ςΑ  
Operating Temperature Range  
Storage Temperature Range  
MSOP-8 Power Dissipation  
SO-8 Power Dissipation  
VDD  
RSW-osc  
REL-osc  
Gnd  
1
2
3
4
8
7
6
5
VA  
VB  
CS  
LX  
MSOP-8  
and  
SO-8  
400mW  
Note:  
*All voltages are referenced to GND.  
Top View  
11/12/01  
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability  
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to  
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the  
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.  
123456

中文翻译

下载PDF

与HV826X相关器件

型号 品牌 获取价格 描述 数据表
HV828X SUPERTEX

获取价格

 		EL Driver, 1-Segment, DIE
HV829A SUPERTEX

获取价格

 		High Voltage EL Lamp Driver
HV829ASG SUPERTEX

获取价格

 		High Voltage EL Lamp Driver
HV829B SUPERTEX

获取价格

 		High Voltage EL Lamp Driver
HV829BSG SUPERTEX

获取价格

 		High Voltage EL Lamp Driver
HV830 SUPERTEX

获取价格

 		High Voltage EL Lamp Driver
HV830 MICROCHIP

获取价格

 		HV830 is a high-voltage driver designed for driving EL lamps of up to 50nF. EL lamps great
HV830_07 SUPERTEX

获取价格

 		High Voltage EL Lamp Driver IC
HV8308DJ ETC

获取价格

 		Interface IC
HV8308PJ ETC

获取价格

 		Interface IC

与HV826X相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证