5秒后页面跳转
HV832X PDF预览

HV832X

更新时间: 2024-11-03 22:48:27
品牌 Logo 应用领域
超科 - SUPERTEX 驱动器
页数 文件大小 规格书
6页 51K
描述
Dual High Voltage, Low Noise EL Lamp Driver

HV832X 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
零件包装代码:DIE包装说明:DIE,
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.92
其他特性:THE DEVICE CAN DRIVE TWO EL LAMPS接口集成电路类型:EL DISPLAY DRIVER
JESD-30 代码:X-XUUC-NJESD-609代码:e0
复用显示功能:NO功能数量:1
区段数:2最高工作温度:85 °C
最低工作温度:-40 °C封装主体材料:UNSPECIFIED
封装代码:DIE封装形状:UNSPECIFIED
封装形式:UNCASED CHIP峰值回流温度(摄氏度):NOT SPECIFIED
认证状态:Not Qualified最大供电电压:5 V
最小供电电压:2 V标称供电电压:3 V
表面贴装:YES温度等级:INDUSTRIAL
端子面层:TIN LEAD端子形式:NO LEAD
端子位置:UPPER处于峰值回流温度下的最长时间:NOT SPECIFIED
Base Number Matches:1

HV832X 数据手册

 浏览型号HV832X的Datasheet PDF文件第2页浏览型号HV832X的Datasheet PDF文件第3页浏览型号HV832X的Datasheet PDF文件第4页浏览型号HV832X的Datasheet PDF文件第5页浏览型号HV832X的Datasheet PDF文件第6页 
HV832  
Dual High Voltage, Low Noise EL Lamp Driver  
Features  
General Description  
8-pin dual EL driver IC  
The Supertex HV832 is a high voltage driver designed for driving  
two EL lamps with a combined area of 3.5 square inches. The  
input supply voltage range is from 2.0V to 5.0V. The device is  
designed to reduce the amount of audible noise emitted by the  
lamp. The device uses a single inductor and a minimum number  
of passive components. The nominal regulated output voltage  
that is applied to the EL lamp is ±90V.  
Input control for lamp selection  
Split supply capability  
Patented output timing  
One minature inductor to power both lamps  
150nA shutdown current  
The HV832 has an internal oscillator, a switching MOSFET, and  
twohighvoltageELlampdrivers. Thefrequencyfortheswitching  
MOSFETis set at 51KHz nominal. The ELlamp driver frequency  
is set by dividing the MOSFET switching frequency by 128. An  
external inductor is connected between the LX and VDD pins or  
VIN for split supply applications. A 0.001 to 0.01µF, 100V  
capacitor is connected between CS and Ground. The EL lamps  
are connected between EL1 to Com and EL2 to Com.  
Wide input voltage range (2.0V to 5.0V)  
Output voltage regulation  
No SCR output  
Applications  
Dual display cell phones  
Keypad and LCD backlighting  
Dual segment lamps  
An input control pin is available to select various modes of the  
device. Each logic pulse applied to the control pin will cause the  
device to change to the next mode. The sequence for the modes  
is: (1) EL1 on only, (2) EL2 on only, (3) both EL1 and EL2 on, and  
(4) device shuts down. During power up of the device, the mode  
will default to shut down.  
Handheld wireless communication devices  
The switching MOSFET charges the external inductor and  
discharges it into the capacitor at Cs. The voltage at CS will start  
to increase. Once the voltage at Cs reaches a nominal value of  
90V, the switching MOSFETis turned off to conserve power. The  
outputs EL1 to Com and EL2 to Com are configured as H bridges  
EL1/EL2 and Com are switching in opposite states to achieve  
180V across the EL lamp.  
Typical Application  
VDD  
Logic Input Pulse  
EL Lamp 1  
1
EL2  
8
EL1  
VDD  
EL Lamp 2  
Com  
CS  
7
6
5
2
3
4
Control  
GND  
LX  
+
VIN  
CS  
HV832MG  
CIN  
_
LX  
12/13/01  
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability  
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to  
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the  
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.  

与HV832X相关器件

型号 品牌 获取价格 描述 数据表
HV833 SUPERTEX

获取价格

High Voltage EL Lamp Driver
HV833 MICROCHIP

获取价格

HV833 is a high voltage driver designed for driving EL lamps of up to 35nF (10-12in2). The
HV833_07 SUPERTEX

获取价格

High Voltage EL Lamp Driver
HV833DB1 SUPERTEX

获取价格

EL Lamp Driver
HV833MG SUPERTEX

获取价格

High Voltage EL Lamp Driver
HV833MG-G SUPERTEX

获取价格

High Voltage EL Lamp Driver
HV833X SUPERTEX

获取价格

High Voltage EL Lamp Driver
HV835 SUPERTEX

获取价格

Low Noise Dual EL Lamp Driver
HV835K7-G SUPERTEX

获取价格

Low Noise Dual EL Lamp Driver
HV839 SUPERTEX

获取价格

High Voltage Dual EL Lamp Driver