5秒后页面跳转
捷配首页

Datasheet > HIP6302CBZA-T
HIP6302CBZA-T PDF预览

HIP6302CBZA-T

更新时间： 2024-11-08 20:59:23
品牌 Logo 应用领域
瑞萨 - RENESAS 开关光电二极管
页数 文件大小 规格书
16页 753K
描述
Microprocessor CORE Voltage Regulator Multiphase Buck PWM Controller; SOIC16; Temp Range: 0° to 70°

阅读下载

中文翻译

获取价格

HIP6302CBZA-T 技术参数

是否Rohs认证： 符合生命周期：Transferred
零件包装代码：SOIC包装说明：SOP, SOP16,.15
针数：16Reach Compliance Code：compliant
ECCN代码：EAR99HTS代码：8542.39.00.01
Factory Lead Time：1 week风险等级：5.15
模拟集成电路 - 其他类型：SWITCHING CONTROLLER控制模式：CURRENT/VOLTAGE-MODE
控制技术：PULSE WIDTH MODULATION最大输入电压：5.25 V
最小输入电压：4.75 V标称输入电压：5 V
JESD-30 代码：R-PDSO-G16JESD-609代码：e3
长度：9.9 mm湿度敏感等级：3
功能数量：1端子数量：16
最高工作温度：70 °C最低工作温度：
封装主体材料：PLASTIC/EPOXY封装代码：SOP
封装等效代码：SOP16,.15封装形状：RECTANGULAR
封装形式：SMALL OUTLINE峰值回流温度（摄氏度）：260
认证状态：Not Qualified座面最大高度：1.75 mm
子类别：Switching Regulator or Controllers表面贴装：YES
切换器配置：PHASE-SHIFT最大切换频率：1500 kHz
温度等级：COMMERCIAL端子面层：Matte Tin (Sn) - annealed
端子形式：GULL WING端子节距：1.27 mm
端子位置：DUAL处于峰值回流温度下的最长时间：40
宽度：3.9 mmBase Number Matches：1

HIP6302CBZA-T 数据手册

 浏览型号HIP6302CBZA-T的Datasheet PDF文件第2页浏览型号HIP6302CBZA-T的Datasheet PDF文件第3页浏览型号HIP6302CBZA-T的Datasheet PDF文件第4页浏览型号HIP6302CBZA-T的Datasheet PDF文件第5页浏览型号HIP6302CBZA-T的Datasheet PDF文件第6页浏览型号HIP6302CBZA-T的Datasheet PDF文件第7页 
DATASHEET  
HIP6302  
FN4766  
Rev.3.00  
December 27, 2004  
Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller  
The HIP6302 multi-phase PWM control IC together with its  
companion gate drivers, the HIP6601, HIP6602 or HIP6603  
Features  
• Multi-Phase Power Conversion  
and Intersil MOSFETs provides a precision voltage  
regulation system for advanced microprocessors.  
Multiphase power conversion is a marked departure from  
earlier single phase converter configurations previously  
employed to satisfy the ever increasing current demands of  
modern microprocessors. Multi-phase convertors, by  
distributing the power and load current results in smaller and  
lower cost transistors with fewer input and output capacitors.  
These reductions accrue from the higher effective  
conversion frequency with higher frequency ripple current  
due to the phase interleaving process of this topology. For  
example, a two phase convertor operating at 350kHz will  
have a ripple frequency of 700kHz. Moreover, greater  
convertor bandwidth of this design results in faster response  
to load transients.  
• Precision Channel Current Sharing  
- Loss Less Current Sampling - Uses r  
• Precision CORE Voltage Regulation  
DS(ON)  
- 1% System Accuracy Over Temperature  
• Microprocessor Voltage Identification Input  
- 5-Bit VID Input  
- 1.100V to 1.850V in 25mV Steps  
- Programmable “Droop” Voltage  
• Fast Transient Recovery Time  
• Over Current Protection  
• High Ripple Frequency, (Channel Frequency) Times  
Number Channels . . . . . . . . . . . . . . . . . .100kHz to 3MHz  
Outstanding features of this controller IC include  
programmable VID codes from the microprocessor that  
range from 1.100V to 1.850V with a system accuracy of  
1%. Pull up currents on these VID pins eliminates the need  
for external pull up resistors. In addition “droop”  
compensation, used to reduce the overshoot or undershoot  
of the CORE voltage, is easily programmed with a single  
resistor.  
• Pb-Free Available (RoHS Compliant)  
Ordering Information  
o
PART NUMBER TEMP. ( C)  
PACKAGE  
PKG. DWG. #  
M16.15  
HIP6302CB  
0 to 70  
0 to 70  
16 Ld SOIC  
HIP6302CBZ  
(See Note)  
16 Ld SOIC  
(Pb-Free)  
M16.15  
Another feature of this controller IC is the PGOOD monitor  
circuit which is held low until the CORE voltage increases,  
during its Soft-Start sequence, to within 10% of the  
programmed voltage. Over-voltage, 15% above  
HIP6302CBZA  
(See Note)  
0 to 70  
16 Ld SOIC  
(Pb-Free)  
M16.15  
HIP6302EVAL1  
Evaluation Platform  
programmed CORE voltage, results in the converter shutting  
down and turning the lower MOSFETs ON to clamp and  
protect the microprocessor. Under voltage is also detected  
and results in PGOOD low if the CORE voltage falls 10%  
below the programmed level. Over-current protection  
reduces the regulator current to less than 25% of the  
programmed trip value. These features provide monitoring  
and protection for the microprocessor and power system.  
*Add “-T” suffix to part number for tape and reel packaging.  
NOTE: Intersil Pb-free products employ special Pb-free material sets; molding  
compounds/die attach materials and 100% matte tin plate termination finish,  
which are RoHS compliant and compatible with both SnPb and Pb-free  
soldering operations. Intersil Pb-free products are MSL classified at Pb-free  
peak reflow temperatures that meet or exceed the Pb-free requirements of  
IPC/JEDEC J STD-020.  
Pinout  
HIP6302 (SOIC)  
TOP VIEW  
1
2
3
4
5
6
7
8
16  
V
VID4  
VID3  
CC  
15 PGOOD  
14 ISEN1  
13 PWM1  
12 PWM2  
11 ISEN2  
10 VSEN  
VID2  
VID1  
VID0  
COMP  
FB  
FS/DIS  
9
GND  
FN4766 Rev.3.00  
Page 1 of 16  
December 27, 2004  
1234567...16

中文翻译

下载PDF

与HIP6302CBZA-T相关器件

型号 品牌 获取价格 描述 数据表
HIP6302CBZ-T RENESAS

获取价格

 		Microprocessor CORE Voltage Regulator Multiphase Buck PWM Controller; SOIC16; Temp Range:
HIP6302EVAL1 INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6302V ETC

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6302VCB INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6302VCB-T INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6302VCBZ INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6302VCBZ-T INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6303 INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6303CB INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller
HIP6303CB-T INTERSIL

获取价格

 		Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

与HIP6302CBZA-T相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证