100V, 2A Peak, High Frequency Half-Bridge Drivers with
Rising Edge Delay Timer
HIP2122, HIP2123
Features
• 9 Ld TDFN “B” Package Compliant with 100V Conductor
Spacing Guidelines per IPC-2221
The HIP2122 and HIP2123 are 100V, high frequency, half-bridge
MOSFET driver ICs. They are based on the popular ISL2100A and
ISL2101A half-bridge drivers. Like the ISL2100A, two logic
inputs, LI and HI, control both bridge outputs, LO and HO. All logic
• Break-Before-Make Dead-Time Prevents Shoot-through and is
adjustable up to 220ns
inputs are V tolerant.
DD
• Bootstrap Supply Max Voltage to 114VDC
• Wide Supply Voltage Range (8V to 14V)
• Supply Undervoltage Protection
These drivers have a programmable dead-time to insure
break-before-make operation between the high-side and low-side
drivers. The dead-time is adjustable up to 220ns. The internal
logic does not prevent both outputs from turning on
simultaneously if both inputs are high simultaneously for a time
greater than the programmed delay.
• CMOS Compatible Input Thresholds with Hysteresis (HIP2122)
• 1.6Ω/1Ω Typical Output Pull-up/Pull-down Resistance
• On-Chip 1Ω Bootstrap Diode
A single PWM logic input controls both bridge outputs (HO, LO).
An enable pin (EN), when low, drives both outputs to a low state.
Applications
• Telecom Half-Bridge DC/DC Converters
• UPS and Inverters
All logic inputs are V tolerant and the HIP2122 has CMOS
DD
inputs with hysteresis for superior operation in noisy
environments.
• Motor Drives
The HIP2122 has hysteretic inputs with thresholds that are
proportional to V . The HIP2123 has 3.3V logic/TTL compatible
inputs.
DD
• Class-D Amplifiers
• Forward Converter with Active Clamp
Two package options are provided. The 10 lead 4x4 DFN package
has standard pinouts. The 9 lead 4x4 DFN package omits pin 2 to
comply with 100V conductor spacing per IPC-2221.
Related Literature
• FN7668, HIP2120, HIP2121 “100V, 2A Peak, High Frequency
Half-Bridge Drivers with Adjustable Dead Time Control and
PWM Input”
200
160
140
120
100
HALF
BRIDGE
100V MAX
HIP2122, HIP2123
VDD
HB
HI
LI
80
SECONDARY
CIRCUITS
HO
HS
PWM
CONTROLLER
60
RDT
VSS
FEEDBACK
WITH
ISOLATION
40
20
LO
EPAD
8
16
24
32 40 48 56 64 80
RDT (kΩ)
FIGURE 1. TYPICAL APPLICATION
FIGURE 2. DEAD-TIME vs TIMING RESISTOR
December 23, 2011
FN7670.0
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas Inc. 2011. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1