Configuration Devices for SRAM-Based
LUT Devices
CF52005-3.0
Datasheet
This datasheet describes configuration devices for SRAM-based look-up table (LUT)
devices.
Supported Devices
Table 1 lists the supported Altera configuration devices.
Table 1. Altera Configuration Devices
Cascaded
Support
Recommended
Device
EPC1
Memory Size (Bits)
ISP Support
Reprogrammable
Operating Voltage (V)
1,046,496
1,695,680
65,536
No
Yes
No
No
No
No
Yes
Yes
No
No
Yes
No
No
No
No
5.0 or 3.3
5.0 or 3.3
5.0
EPC2
EPC1064
EPC1064V
EPC1213
EPC1441
65,536
No
3.3
212,942
440,800
Yes
No
5.0
5.0 or 3.3
Features
Configuration devices for SRAM-based LUT devices offer the following features:
■
Configures Altera ACEX 1K, APEX 20K (including APEX 20K, APEX 20KC, and
APEX 20KE), APEX II, Arria GX, Cyclone, Cyclone II, FLEX 10K (including
FLEX 10KE and FLEX 10KA) Mercury, Stratix, Stratix GX, Stratix II, and
Stratix II GX devices
■
■
■
Easy-to-use four-pin interface
Low current during configuration and near-zero standby mode current
Programming support with the Altera Programming Unit (APU) and
programming hardware from Data I/O, BP Microsystems, and other third-party
programmers
■
Available in compact plastic packages
■
■
■
8-pin plastic dual in-line (PDIP) package
20-pin plastic J-lead chip carrier (PLCC) package
32-pin plastic thin quad flat pack (TQFP) package
■
EPC2 device has reprogrammable flash configuration memory
© 2012 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS,
QUARTUS and STRATIX words and logos are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark
Office and in other countries. All other words and logos identified as trademarks or service marks are the property of their
respective holders as described at www.altera.com/common/legal.html. Altera warrants performance of its semiconductor
products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use
of any information, product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are
advised to obtain the latest version of device specifications before relying on any published information and before placing orders
for products or services.
ISO
9001:2008
Registered
101 Innovation Drive
San Jose, CA 95134
www.altera.com
January 2012 Altera Corporation
Subscribe