Enpirion® Power Datasheet
EC7100VQI PWM DC/DC Controller with
VS Inputs for FPGA Power Regulator
DS-1043
Datasheet
The Altera® Enpirion® EC7100VQI is a Single-Phase
Features
Synchronous-Buck PWM controller. The wide 3.3V to 25V input
voltage range is ideal for systems that run on battery or AC-
adapter power sources. The EC7100VQI is a low-cost solution for
applications requiring dynamically selected slew-rate controlled
output voltages. The soft-start and dynamic setpoint slew-rates are
capacitor programmed. Voltage identification logic-inputs select
four resistor-programmed setpoint reference voltages that directly
set the output voltage of the converter between 0.5V and 1.5V, and
up to 5V with a feedback voltage divider.
•
•
•
Input Voltage Range: 3.3V to 25V
Output Voltage Range: 0.5V to 5V
Precision Regulation
-
-
Frequency Control Loop
±0.5% System Accuracy Over -10°C to +100°C
•
•
Optimal Transient Response
Output Remote Sense
•
Extremely Flexible Output Voltage Programmability
The EC7100VQI modulator has equivalent light-load efficiency,
faster transient performance, accurately regulated frequency
control and all internal compensation. These updates, together
with integrated MOSFET drivers and schottky bootstrap diode,
allow for a high-performance regulator that is highly compact and
needs few external components. The EC7100VQI has differential
remote sensing for output voltage and selectable switching
frequency. For maximum efficiency, the converter automatically
enters diode-emulation mode (DEM) during light-load conditions
such as system standby.
-
-
2-Bit VS Selects Four Independent Setpoint Voltages
Simple Resistor Programming of Setpoint Voltages
•
Selectable 300kHz, 500kHz, 600kHz or 1MHz PWM Frequency in
Continuous Conduction
•
•
Automatic Diode Emulation Mode for Highest Efficiency
Power-OK Monitor for Soft-Start and Fault Detection
Applications
FPGA power
•
•
•
Digital processor power
Mixed-signal ASIC power
RAVIN2
+5V
VIN
CAVIN1
3.3V TO 25V
CAVIN2
CIN
RFB1
NSNS1
QHS
NSNS
VS1
BOOT
UGATE
SW
1
2
3
4
5
6
16
15
14
13
12
11
VOUT
LO
GPIO
0.5V TO 5V
VS0
GND
QLS
EN
SREF
SET0
SET1
CO
RSET1
POK
FSW
CSEN
CBOOT
NSNS1
RSET3
RO
RFB
0
FIGURE 1. EC7100VQI APPLICATION SCHEMATIC WITH FOUR OUTPUT VOLTAGE SETPOINTS AND DCR CURRENT SENSE
© 2014 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, HARDCOPY, MAX, MEGACORE, NIOS,
QUARTUS and STRATIX words and logos are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in
other countries. All other words and logos identified as trademarks or service marks are the property of their respective holders as described at
www.altera.com/common/legal.html. Altera warrants performance of its semiconductor products to current specifications in accordance with
Altera's standard warranty, but reserves the right to make changes to any products and services at any time without notice. Altera assumes no
responsibility or liability arising out of the application or use of any information, product, or service described herein except as expressly agreed
to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying on any published
information and before placing orders for products or services.
ISO
9001:2008
Registered
101 Innovation Drive
San Jose, CA 95134
www.altera.com
March 2014 Altera Corporation
Subscribe
09613
March 14, 2014
Rev A