DS26324
3.3V, 16-Channel, E1/T1/J1
Short-Haul Line Interface Unit
www.maxim-ic.com
GENERAL DESCRIPTION
FEATURES
Cꢀ16 E1, T1, or J1 Short-Haul Line Interface Units
CꢀIndependent E1, T1, or J1 selections
CꢀSoftware-Selectable Transmit and Receive-Side
Impedance Matching
The DS26324 is a 16-channel short-haul line
interface unit (LIU) that supports E1/T1/J1 from a
single 3.3V power supply. A wide variety of
applications are supported through internal
impedance matching. A single bill of material can
CꢀCrystal Less Jitter Attenuator
CꢀSelectable Single-Rail and Dual-Rail Mode and
AMI or HDB3/ B8ZS Line Encoding and
Decoding
support
E1/T1/J1
with
minimum
external
components. Redundancy is supported through
nonintrusive monitoring, optimal high-impedance
modes, and configurable 1:1 or 1+1 backup
enhancements. An on-chip synthesizer generates the
E1/T1/J1 clock rates by a single master clock input of
various frequencies. Two clock output references are
also offered. The device is offered a 256-pin TEBGA,
the smallest package available for a 16-channel LIU.
CꢀDetection and Generation of AIS
CꢀDigital/Analog Loss of Signal Detection as per
T1.231, G.775, and ETSI 300233
CꢀExternal Master Clock can be Multiple of 2.048 or
1.544MHz for T1/J1 or E1 Operation (This clock
will be internally adapted for T1 or E1 Use.)
CꢀReceiver Signal Level Indicator from -2.5dB to
-20dB in 2.5dB Increments
APPLICATIONS
T1 Digital Cross-Connects
CꢀTwo Built-In BERT Testers for Diagnostics
Cꢀ8-Bit Parallel Interface Support for Intel or
Motorola Mode, or 4-Wire Serial Interface
CꢀTransmit Short-Circuit Protection
ATM and Frame Relay Equipment
Wireless Base Stations
ISDN Primary Rate Interface
E1/T1/J1 Multiplexer and Channel Banks
E1/T1/J1 LAN/WAN Routers
CꢀG.772 Nonintrusive Monitoring
CꢀReceive Monitor Mode Handles Combinations of
14dB or 20dB of Resistive Attenuation Along with
12dB to 30dB of Cable Attenuation.
FUNCTIONAL DIAGRAM
CꢀSpecification Compliance to the Latest T1/E1
Standards—ANSI T1.102, AT&T Pub 62411,
T1.231, T1.403, ITU G.703, G.742, G.775,
G.823, ETSI 300 166, and ETSI 300 233
CꢀSingle 3.3V Supply with 5V Tolerant I/O
CꢀJTAG Boundary Scan as per IEEE 1149.1
JTAG
SOFTWARE CONTROL
AND JTAG
LOSS
RTIP
RPOS
RNEG
RCLK
RECEIVER
RRING
ORDERING INFORMATION
TPOS
TTIP
TNEG
TRANSMITTER
TCLK
PART
TEMP RANGE PIN-PACKAGE
TRING
1
DS26324G
0°C to +70°C 256 TEBGA
DS26324GN -40°C to +85°C 256 TEBGA
16
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device
may be simultaneously available through various sales channels. For information about device errata, click here: www.maxim-ic.com/errata.
1 of 112
REV: 070105