DS1077L
3V EconOscillator/Divider
www.maxim-ic.com
FEATURES
PIN ASSIGNMENTS
C Processor-controlled or stand-alone solid-
state oscillator
OUT1
OUT0
VCC
1
2
3
4
8
7
6
5
SCL
C Frequency changes on the fly
SDA
C Dual, low-jitter, synchronous fixed-
CTRL1
CTRL0
frequency outputs
GND
C 2-wire serial interface
C Frequency outputs 4.87kHz to 66.666MHz
±1.25% variation over temperature and
voltage
150mil SO
118mil µSOP*
C ±0.5% initial tolerance
C Nonvolatile frequency settings
C Single 2.7V to 3.6V supply
C No external components
C Power-down mode
PIN DESCRIPTIONS
OUT1
OUT0
VCC
- Main Oscillator Output
- Reference Output
- Power-Supply Voltage
- Ground
GND
CTRL1
CTRL0
SDA
- Control Pin for OUT1
- Control Pin for OUT0
- 2-Wire Serial Data
Input/Output
C Synchronous output gating
STANDARD FREQUENCY OPTION
Note: x denotes package option
SCL
- 2-Wire Serial Clock
DS1077Lx-40
DS1077Lx-50
DS1077Lx-60
DS1077Lx-66
40.000MHz to 4.87kHz
50.000MHz to 6.09kHz
60.000MHz to 7.32kHz
66.666MHz to 8.13kHz
ORDERING INFORMATION
Note: XXX denotes frequency option
DS1077LZ-XXX 8-pin 150mil SO
DS1077LU-XXX* 8-pin 118mil µSOP
Contact the factory for the availability of
additional frequencies.
DESCRIPTION
The DS1077L is a dual-output, programmable, fixed-frequency oscillator requiring no external
components for operation. The DS1077L can be used as a processor-controlled frequency synthesizer or
as a stand-alone oscillator. The two synchronous output operating frequencies are user-adjustable in
submultiples of the master frequency through the use of two on-chip programmable prescalers and
dividers. The specific output frequencies chosen are stored in nonvolatile (EEPROM) memory. The
DS1077L defaults to these values upon power-up.
The DS1077L features a 2-wire serial interface that allows in-circuit on-the-fly programming of the
programmable prescalers (P0 & P1) and divider (N) with the desired values being stored in nonvolatile
(EEPROM) memory. Design changes can be accommodated in-circuit, on-the-fly by simply programming
different values into the device (or reprogramming previously programmed devices). Alternatively, for
fixed-frequency applications previously programmed devices can be used and no connection to the serial
interface is required. Preprogrammed devices can be ordered in customer-requested frequencies.
The DS1077L is available in SO or µSOP packages, allowing the generation of a clock signal easily,
economically, and using minimal board area. Chip-scale packaging is also available on request.
*Future product. Contact factory for availability.
1 of 20
010202