5秒后页面跳转
BQ2011SN-D118G4 PDF预览

BQ2011SN-D118G4

更新时间: 2024-10-28 02:55:07
品牌 Logo 应用领域
德州仪器 - TI 仪表
页数 文件大小 规格书
21页 195K
描述
Gas Gauge IC for High Discharge Rates

BQ2011SN-D118G4 数据手册

 浏览型号BQ2011SN-D118G4的Datasheet PDF文件第2页浏览型号BQ2011SN-D118G4的Datasheet PDF文件第3页浏览型号BQ2011SN-D118G4的Datasheet PDF文件第4页浏览型号BQ2011SN-D118G4的Datasheet PDF文件第5页浏览型号BQ2011SN-D118G4的Datasheet PDF文件第6页浏览型号BQ2011SN-D118G4的Datasheet PDF文件第7页 
bq2011  
Gas Gauge IC for  
High Discharge Rates  
Nominal available charge may be di-  
Features  
Conservative and repeatable  
measurement of available charge  
in rechargeable batteries  
General Description  
rectly indicated using a five-seg-  
ment LED display. These segments  
are used to indicate graphically the  
nominal available charge.  
The bq2011 Gas Gauge IC is intended  
for battery-pack installation to main-  
tain an accurate record of available  
battery charge. The IC monitors a  
voltage drop across a sense resistor  
connected in series between the nega-  
tive battery terminal and ground to  
determine charge and discharge ac-  
tivity of the battery. The bq2011 is  
designed for systems such as power  
tools with very high discharge rates.  
Designed for portable equipment  
such as power tools with high dis-  
charge rates  
The bq2011 supports a simple single-  
line bidirectional serial link to an exter-  
nal processor (common ground). The  
bq2011 outputs battery information in  
response to external commands over the  
serial link. To support subassembly  
testing, the outputs may also be con-  
trolled by command. The external proc-  
essor may also overwrite some of the  
bq2011 gas gauge data registers.  
Designed for battery pack inte-  
gration  
- 120µA typical standby current  
(self-discharge estimation mode)  
Battery self-discharge is estimated  
based on an internal timer and tem-  
perature sensor. Compensations for  
battery temperature and rate of  
charge or discharge are applied to  
the charge, discharge, and  
selfdischarge calculations to provide  
available charge information across  
a wide range of operating conditions.  
Initial battery capacity is set using  
the PFC and MODE pins. Actual  
battery capacity is automatically  
“learned” in the course of a dis-  
charge cycle from full to empty and  
may be displayed depending on the  
display mode.  
- Small size enables imple-  
1
The bq2011 may operate directly  
from four cells. With the REF output  
and an external transistor, a simple,  
inexpensive regulator can be built to  
provide VCC from a greater number  
of cells.  
mentations in as little as  
square inch of PCB  
2
Direct drive of LEDs for capacity  
display  
Self-discharge compensation us-  
ing internal temperature sensor  
Internal registers include available  
charge, temperature, capacity, battery  
ID, and battery status.  
Simple single-wire serial commu-  
nications port for subassembly  
testing  
16-pin narrow SOIC  
Pin Connections  
Pin Names  
MODE  
SEG1  
SEG2  
SEG3  
SEG4  
SEG5  
PFC  
Display mode output  
LED segment 1  
LED segment 2  
LED segment 3  
LED segment 4  
LED segment 5  
NC  
DQ  
No connect  
MODE  
1
2
3
4
5
6
16  
15  
14  
13  
12  
11  
V
CC  
Serial communications  
input/output  
SEG  
SEG  
SEG  
SEG  
SEG  
REF  
NC  
DQ  
RBI  
SB  
1
2
3
4
5
RBI  
SB  
Register backup input  
Battery sense input  
Display control input  
Sense resistor input  
3.0–6.5V  
DISP  
SR  
Programmed full count  
selection input  
PFC  
7
8
10  
9
DISP  
SR  
VCC  
VSS  
V
SS  
REF  
Voltage reference output  
Negative battery terminal  
16-Pin Narrow SOIC  
PN201101.eps  
2/96 E  
1

BQ2011SN-D118G4 替代型号

型号 品牌 替代类型 描述 数据表
BQ2010SN-D107TRG4 TI

完全替代

Gas Gauge IC
BQ2040SN-D111TRG4 TI

完全替代

Gas Gauge IC With SMBus Interface

与BQ2011SN-D118G4相关器件

型号 品牌 获取价格 描述 数据表
BQ2011SN-D118TR TI

获取价格

Gas Gauge IC for High Discharge Rates
BQ2011SN-N TI

获取价格

Gas Gauge IC for High Discharge Rates
BQ2012 TI

获取价格

Gas Gauge IC With Slow-Charge Control
BQ2012PN ETC

获取价格

Battery Management
BQ2012PN-N ETC

获取价格

Battery Management
BQ2012SN TI

获取价格

Gas Gauge IC With Slow-Charge Control
BQ2012SN-D107 TI

获取价格

具有单总线 (DQ) 接口、5 个 LED 驱动器和慢充控制的镍镉电池/镍氢电池电量监测计
BQ2012SN-D107TR TI

获取价格

具有单总线 (DQ) 接口、5 个 LED 驱动器和慢充控制的镍镉电池/镍氢电池电量监测计
BQ2012SND107TRG4 TI

获取价格

1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16, GREEN, PLASTIC, MS-012 AC, SOIC-16
BQ2012SNN TI

获取价格

Gas Gauge IC With Slow-Charge Control