5秒后页面跳转
BD71815AGW PDF预览

BD71815AGW

更新时间: 2024-11-05 11:10:59
品牌 Logo 应用领域
罗姆 - ROHM 电池开关驱动驱动器计数器
页数 文件大小 规格书
106页 2819K
描述
BD71815AGW凭借罗姆出众的模拟设计技术实现了“i.MX 7Solo/7Dual”处理器驱动的很好的电源系统。它不仅拥有与以往产品同等的功率转换效率(82%以上),还成功将待机时的电流消耗减少了16%※1,这是在应用中实现低功耗的关键。此外,还内置了30V耐压的带输入过电压保护功能(OVP)的Li-ion电池充电器和LED驱动器(6灯)。由于开关频率高速化(6MHz)实现的外接线圈的小型化、搭载功能的优化、以及采用WL-CSP的小型封装(16mm²: 面积比以往减少75%)的应用,使得包含外接零件在内的贴装面积大幅度减少。内置库仑计数器,采用搭载罗姆独创算法的参考软件,实现了高精度电池余量监视。本产品对移动设备所追求的“低功耗”、“小型化”、“高精度”做出了很大贡献。※1 Buck converter部每个信道的消耗电流

BD71815AGW 数据手册

 浏览型号BD71815AGW的Datasheet PDF文件第2页浏览型号BD71815AGW的Datasheet PDF文件第3页浏览型号BD71815AGW的Datasheet PDF文件第4页浏览型号BD71815AGW的Datasheet PDF文件第5页浏览型号BD71815AGW的Datasheet PDF文件第6页浏览型号BD71815AGW的Datasheet PDF文件第7页 
Datasheet  
System PMIC for  
Battery Powered Systems  
BD71815AGW  
General Description  
Battery Monitoring and Alarm Output  
-Under Voltage Alarm while discharging  
-Over Current Alarm  
-Over/Under Temperature Alarm  
-Programmable thresholds and time durations  
Real Time Clock with 32.768kHz crystal oscillator  
-32.768kHz clock output  
BD71815AGW is a single-chip power management IC  
for battery-powered portable devices. The IC integrates  
5 buck converters, 8 LDOs, a boost driver for LED, and  
a 500mA single-cell linear charger. Also included is a  
Coulomb counter, a real-time clock (RTC), a 32 kHz  
crystal oscillator and a general-purpose output (GPO).  
(Open Drain or CMOS Output Selectable)  
1 GPO (Open Drain or CMOS Output Selectable)  
Power Control I/O  
The IC’s buck converters supply power to the application  
processor as well as system peripherals such as DDR  
memory, wireless modules, and touch controllers. These  
regulators maintain high efficiency over a wide range of  
current loads by supporting both PFM and PWM modes.  
They also operate at a high switching frequency of  
6MHz, which allows the use of smaller and cheaper  
inductors and capacitors. The regulator supplying the  
processor core also supports Dynamic Voltage Scaling  
(DVS).  
-Power On/Off control input  
-Standby Input for switching RUN/SUSPEND State  
-Reset Input to reset hung PMIC  
-Power On Reset output  
1 LED Indicator  
-Indicate charger status  
I2C interface  
Applications  
Features  
E-Book reader  
5 buck converters:  
Media players with smart devices, wearables  
Portable Navigation Devices with Home POS,  
Human Machine Interfaces  
- 3 1000mA buck converters  
- 1 800mA buck converter  
- 1 500mA buck converter  
3 general-purpose LDOs  
- 2 100mA LDOs  
Key Specifications  
- 1 50mA LDO  
Input Voltage Range (DCIN):  
Input Voltage Range (VIN, VSYS): 2.9V to 5.5V  
Input Voltage Range (DVDD):  
Off Current:  
3.5V to 28V  
LDO for DDR Reference Voltage (DVREF)  
LDO for Secure Non-Volatile Storage (SNVS)  
LDO for Low-Power State Retention (LPSR)  
LDO for SD Card with dedicated enable terminal  
LDO for SD Card Interface with dedicated terminal  
to dynamically change output voltage  
White LED Boost Converter  
1.5V to 3.4V  
20 μA (Typ)  
[RTC+ Coulomb counter+ LDO_SNVS only]  
Operating temperature range:  
-40°C to +85°C  
-25mA LED Boost Converter  
Package  
UCSP55M4C  
W(Typ) x D(Typ) x H(Max)  
4.0mm x 4.0mm x 0.62mm  
Single-cell Linear LIB Charger with 30V OVP  
-Selectable charging voltage: 3.72 to 4.34 V  
-Programmable charge current: 100 to 500mA  
-Support for up to 2000mA charge current using  
external MOSFET  
D71815A  
-DCIN over voltage protection  
-Battery over voltage protection  
-Battery Supplement Mode support  
-Battery Short Circuit Detection  
Voltage Measurement for Thermistor  
-Bias voltage output for External Thermistor  
Embedded Coulomb Counter for Battery Fuel  
Gauging  
-15-bit ΔΣ-ADC with External Current Sense  
Resistor (10 mΩ, ±1% or 30mΩ, ±1%)  
-1-sec cycle, 28-bit accumulation  
-Coulomb count while charging/discharging  
(Unit :mm)  
Product structure : Silicon monolithic integrated circuit This product has no designed protection against radioactive rays  
.www.rohm.com  
TSZ02201-0Q4Q0AB00610-1-2  
3.Mar.2017 Rev.002  
© 2016 ROHM Co., Ltd. All rights reserved.  
1/103  
TSZ22111 14 001  
 
 
 
 
 

与BD71815AGW相关器件

型号 品牌 获取价格 描述 数据表
BD71815AGW-E2 ROHM

获取价格

Power Supply Management Circuit, Adjustable, 15 Channel, PBGA80, UCSP55M4C-80
BD71837AMWV ROHM

获取价格

BD71837AMWV是一款PMIC,集成了i.MX 8M处理器所需的电源和功能,运用了罗
BD71837AMWV-E2 ROHM

获取价格

Power Supply Management Circuit,
BD71847AMWV ROHM

获取价格

BD71847AMWV是融入ROHM多年积累的处理器用电源技术,并集成了恩智浦公司的i.M
BD71850MWV ROHM

获取价格

BD71850MWV是运用罗姆此前积累的处理器用电源技术,集成了i.MX 8M Nano
BD7185AGWL ROHM

获取价格

Power Management LSI
BD7185AGWL-E2 ROHM

获取价格

Power Management LSI
BD719 ISC

获取价格

isc Silicon NPN Power Transistor
BD719 NJSEMI

获取价格

Trans GP BJT NPN 60V 4A
BD71L3SHFV ROHM

获取价格

罗姆的过电压检测IC采用CMOS工艺,实现了高精度、超低消耗电流。输出形式为Nch漏极开路