Features
• Single-voltage Operation
– 5V Read
– 5V Reprogramming
• Fast Read Access Time – 45 ns
• Internal Program Control and Timer
• 8K Word Boot Block with Lockout
• Fast Erase Cycle Time – 1.5 seconds
• Word-by-word Programming – 10 µs/Word Typical
• Hardware Data Protection
• Data Polling for End of Program Detection
• Small 10 x 14 mm VSOP Package
• Typical 10,000 Write Cycles
1-megabit
(64K x 16)
5-volt Only
Flash Memory
Description
The AT49F1024A is a 5-volt-only in-system Flash memory organized as 65,536 words
by 16 bits. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the
devices offer access times to 45 ns with power dissipation of just 275 mW over the
commercial temperature range. When the device is deselected, the CMOS standby
current is less than 100 µA.
AT49F1024A
To allow for simple in-system reprogrammability, the AT49F1024A does not require
high-input voltages for programming. Five-volt-only commands determine the read
and programming operation of the device. Reading data out of the device is similar to
reading from an EPROM. Reprogramming the AT49F1024A is performed by erasing a
block of data (entire chip or main memory block) and then programming on a word-by-
word basis. The typical word programming time is a fast 10 µs. The end of a program
cycle can be optionally detected by the Data Polling feature. Once the end of a byte
program cycle has been detected, a new access for a read or program can begin. The
typical number of program and erase cycles is in excess of 10,000 cycles.
VSOP Top View
Pin Configurations
Type 1
10 x 14 mm
Pin Name
A0 - A15
CE
Function
Addresses
A9
A10
1
40
39
38
37
36
35
34
33
32
31
30
29
28
27
26
25
24
23
22
21
GND
A8
2
A11
3
A7
Chip Enable
Output Enable
Write Enable
A12
4
A6
A13
5
A5
OE
A14
6
A4
A15
7
A3
WE
NC
8
A2
WE
9
A1
I/O0 - I/O15 Data Inputs/Outputs
NC No Connect
VCC
NC
10
11
12
13
14
15
16
17
18
19
20
A0
OE
CE
I/O0
I/O1
I/O2
I/O3
I/O4
I/O5
I/O6
I/O7
GND
I/O15
I/O14
I/O13
I/O12
I/O11
I/O10
I/O9
I/O8
3415B–FLASH–12/03