AP1202
Dual USB High-Side Power Switch
ꢀFeatures
General Description
ꢀ
- Compliant to USB specifications
- Dual independent switches control
- 2.7V to 5.5V input voltage
The AP1202 series are dual integrated high-side
power switch with independent enable and flag
functions, optimized for self-powered and
- 500mA minimum continuous current per port
- 110mΩ typical on-resistance
bus-powered
Universal
Serial Bus
(USB)
applications. The AP1202 series support the
following USB requirements: each switch channel
supplies up to 500mA as required by USB
downstream devices; the switch’s low on-resistance
meets USB voltage drop requirements; fault current
is limited to typically 650mA, well below the UL
25VA safety requirements; and a flag output is
available to indicate fault conditions to the local
USB controller. Soft start eliminates the momentary
voltage drop on the upstream port that may occur
when the switch is enabled in bus-powered
applications.
- 0.75A maximum short circuit current limit
- Independent open-drain fault flag pins
- 110μA typical on-state supply current
- 1μA typical off-state supply current
- Output can be forced higher than input (off-state)
- Thermal shutdown
- 2.4V typical under voltage lockout (UVLO)
- 1ms turn-on (soft-start) and fast turn-off
- Enable active-high (H) or active-low (L)
- 8-pin SOP and PDIP packages
Additional features include thermal shutdown to
prevent catastrophic switch failure from high-current
loads, under voltage lockout (UVLO) to ensure that
the device remains off unless there is a valid input
voltage present, and 3.3V and 5V logic compatible
enable inputs.
ꢀApplications
• USB hubs
• Hot plug-in power supplies
• Battery-charger circuits
ꢀPin Assignments
ꢀPin Descriptions
Name
Description
Enable: Logic-compatible enable
input. ( H: active high, L: active low).
Do not float.
(Top View)
EN1
EN2
EN1 1
FLG1 2
FLG2 3
8 OUT1
7 IN
Fault Flag: Active-low, open-drain
output. Indicates over current,
UVLO, and thermal shutdown.
FLG1
FLG2
AP1202
GND
IN
Supply return.
GND
6
Supply Input: Output MOSFET drain.
Also supplies IC’s internal circuitry.
Connect to positive supply.
EN2
4
5 OUT2
Switch Output: Output MOSFET
source. Typically connect to
switched side of load.
OUT1
OUT2
PDIP/SOP
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of
this product. No rights under any patent accompany the sale of the product.
Rev. 0.4 Feb.10, 2004
1/11