ACS8514 SETS Buddy
ADVANCED COMMS & SENSING
Abbreviations
FINAL
DATASHEET
References
AMI
Alternate Mark Inversion
Analogue Phase Locked Loop
Building Integrated Timing Supply
Digital Frequency Synthesis
Digital Phase Locked Loop
1544 kb/s interface rate
Discrete Time Oscillator
2048 kb/s interface rate
Input - Output
[1] ANSI T1 1.101-1999 (1999)
Synchronization Interface Standard
APLL
BITS
DFS
DPLL
DS1
DTO
E1
[2] AT & T 62411 (12/1990)
ACCUNET® T1.5 Service description and Interface
Specification
[3] ETSI ETS 300 462-3, (01/1997)
Transmission and Multiplexing (TM); Generic
requirements for synchronization networks; Part 3:
The control of jitter and wander within
synchronization networks
I/O
LOF
Loss of Frame Alignment
Loss Of Signal
[4] ETSI ETS 300 462-5 (09/1996)
Transmission and Multiplexing (TM); Generic
requirements for synchronization networks; Part 5:
Timing characteristics of slave clocks suitable for
operation in Synchronous Digital Hierarchy (SDH)
equipment
LOS
LQFP
LVDS
MTIE
NE
Low profile Quad Flat Pack
Low Voltage Differential Signal
Maximum Time Interval Error
Network Element
[5] IEEE 1149.1 (1990)
OCXO
PBO
PDH
PECL
PFD
PLL
Oven Controlled Crystal Oscillator
Phase Build-out
Standard Test Access Port and Boundary-Scan
Architecture
Plesiochronous Digital Hierarchy
Positive Emitter Coupled Logic
Phase and Frequency Detector
Phase Locked Loop
[6] ITU-T G.703 (10/1998)
Physical/electrical characteristics of hierarchical
digital interfaces
[7] ITU-T G.736 (03/1993)
POR
ppb
Power-On Reset
Characteristics of a synchronous digital multiplex
equipment operating at 2048 kbit/s
parts per billion
ppm
pk-pk
R/W
rms
parts per million
[8] ITU-T G.742 (1988)
Second order digital multiplex equipment operating at
8448 kbit/s, and using positive justification
peak-to-peak
Read/Write
[9] ITU-T G.783 (10/2000)
root-mean-square
Characteristics of synchronous digital hierarchy (SDH)
equipment functional blocks
RO
Read Only
RoHS
Restrictive Use of Certain Hazardous
Substances (directive)
[10] ITU-T G.812 (06/1998)
Timing requirements of slave clocks suitable for use
as node clocks in synchronization networks
SDH
Synchronous Digital Hierarchy
SDH/SONET Equipment Clock
Synchronous Equipment Timing source
Synchronous Optical Network
Synchronization Supply Unit
Synchronous Transport Module
Time Deviation
SEC
[11] ITU-T G.813 (08/1996)
SETS
SONET
SSU
Timing characteristics of SDH equipment slave clocks
(SEC)
[12] ITU-T G.822 (11/1988)
STM
Controlled slip rate objectives on an international
digital connection
TDEV
TCXO
Temperature Compensated Crystal
Oscillator
[13] ITU-T G.823 (03/2000)
The control of jitter and wander within digital
networks which are based on the 2048 kbit/s
hierarchy
UI
Unit Interval
WEEE
Waste Electrical and Electronic
Equipment (directive)
Revision 3.00 April 2007 © Semtech Corp.
Page 83
www.semtech.com