PLC-…24UC/1/S/H
PLC-…24UC/1/S/L
PLC INTERFACE With Switch and Integrated
Power Contact Relay
INTERFACE
Data Sheet
101460_en_04
© PHOENIX CONTACT - 03/2008
inserted in the bridge shafts. They eliminate the need for
complicated and time-consuming loop bridges.
1
Description
The 6.2 mm PLC-…24UC/1/S… PLC INTERFACE module
supports "Manual", "Zero", and "Automatic" functions. The
load can be switched directly using the module.
1.3
Additional Advantages
–
Environmentally friendly, cadmium-free power contact
material for loads up to 250 V AC/6 A
1.1
Switching Function
–
–
–
–
–
Integrated input/protective circuit
Depending on the version, the switch can be operated either
by hand or using a screwdriver.
A floating contact provides confirmation for the "Automatic"
switching state.
Safe isolation according to DIN EN 50178
Spring-cage and screw connection types available
6 kVrms electrical isolation between coil and contact
Floating confirmation contact for "Automatic" switching
state
1.2
Optimum Use of Plug-In Bridges
The PLC INTERFACE module achieves maximum
efficiency with the user-friendly FBST plug-in bridge system.
The PLC-…24UC/1/S… makes effective use of the bridging
options for the A1/A2 connection on the coil side, for the
supply at connection 13 on the contact side, and for the
manual input at connection M. Especially effective here are
the 500 mm long color-insulated continuous plug-in bridges
that can easily be cut to the required length and quickly
Make sure you always use the latest documentation.
It can be downloaded at www.download.phoenixcontact.com.
A conversion table is available on the Internet at
www.download.phoenixcontact.com/general/7000_en_00.pdf.
This data sheet is valid for all products listed on the following page: