Dimensions
■ General-purpose and Split Contact Models
Note: Unless otherwise specified, all units are in millimeters and a tolerance of ± 0.4 mm applies to all dimensions
Terminals
General-purpose Models
Solder Terminal (Blank)
Split-contact Models
Screw Terminals (-B)
Screw Terminals (Y-B)
5.6
6.4
9.2
11.9
0.1
25.4
3
11.9
0.2
17.45
20
20
23
17.1
0.2
17.45
0.2
17.45
Five, M3.5 × 5.5
terminal screws
(with toothed
washer)
COM
1
NO
NC
2
1
NO
COM
NC
Three, M4 × 5.5
Terminal screws
(with toothed
washer)
2
3
49.2
Appropriate terminal screw tightening torque:
49.2
0.49 to 0.78 N·m.
Appropriate terminal screw tightening
torque: 0.78 to 1.18 N·m.
Note: With reverse action models (Z-10FM),
the positions of NO and NC terminals
are reversed.
Note: With reverse action models (Z-15GM), the positions of NO and NC terminals are reversed.
Mounting
All switches can be side mounted using M4 mounting screws with
plane washers or spring washers to securely mount the Switch.
Tighten the screws to a torque of 1.18 to 1.47 N·m.
Two, 4.2 dia. mounting holes or M4
0.1
25.4
Versions with panel mount plungers can be panel mounted via the
plunger, provided that the hexagonal nut of the actuator is tightened
to a torque of 2.94 to 4.9 N·m.
Panel Mount Plunger
Panel Mount Roller Plunger
12.5+0.2dia.
12.5+0.2 dia.
0
0
5+0.2
0
13+0.2
0
Note: Mount using either the side mounting holes or the panel mount
plunger, not both. If using the side mounting holes, then remove
the hexagonal nut(s) from the panel mount plunger
.
Accessories (Terminal Covers, Actuators, and Separators): Refer to ‘Z/A/X/DZ Common Accessories’ datasheet
General-purpose Basic Switch Z
155