DATASHEET
X5323, X5325 (Replaces X25323, X25325)
CPU Supervisor with 32kBit SPI EEPROM
FN8131
Rev 3.00
December 9, 2015
These devices combine four popular functions, Power-on
Reset Control, Watchdog Timer, Supply Voltage Supervision,
and Block Lock Protect Serial EEPROM Memory in one
package. This combination lowers system cost, reduces
board space requirements, and increases reliability.
Features
• Selectable watchdog timer
• Low VCC detection and reset assertion
- Five standard reset threshold voltages
- Re-program low VCC reset threshold voltage using
special programming sequence
Applying power to the device activates the power-on reset
circuit which holds RESET/RESET active for a period of
time. This allows the power supply and oscillator to stabilize
before the processor can execute code.
- Reset signal valid to VCC = 1V
• Determine watchdog or low voltage reset with a volatile
flag bit
The Watchdog Timer provides an independent protection
mechanism for microcontrollers. When the microcontroller
fails to restart a timer within a selectable time out interval,
the device activates the RESET/RESET signal. The user
selects the interval from three preset values. Once selected,
the interval does not change, even after cycling the power.
• Long battery life with low power consumption
- <50µA max standby current, watchdog on
- <1µA max standby current, watchdog off
- <400µA max active current during read
• 32kbits of EEPROM
• Built-in inadvertent write protection
- Power-up/power-down protection circuitry
- Protect 0, 1/4, 1/2 or all of EEPROM array with Block
Lock™ protection
The device’s low VCC detection circuitry protects the user’s
system from low voltage conditions, resetting the system
when VCC falls below the minimum VCC trip point.
RESET/RESET is asserted until VCC returns to proper
operating level and stabilizes. Five industry standard VTRIP
thresholds are available, however, Intersil’s unique circuits
allow the threshold to be reprogrammed to meet custom
requirements or to fine-tune the threshold for applications
requiring higher precision.
- In circuit programmable ROM mode
• 2MHz SPI interface modes (0,0 and 1,1)
• Minimize EEPROM programming time
- 32-byte page write mode
- Self-timed write cycle
- 5ms write cycle time (typical)
• 2.7V to 5.5V and 4.5V to 5.5V power supply
operation
• Available packages
- 14 Ld TSSOP, 8 Ld SOIC, 8 Ld PDIP
• Pb-free (RoHS compliant)
Block Diagram
WATCHDOG TRANSITION
DETECTOR
WATCHDOG
TIMER RESET
WP
PROTECT LOGIC
RESET/RESET
X5323 = RESET
SI
DATA
REGISTER
STATUS
REGISTER
SO
RESET AND
WATCHDOG
TIMEBASE
COMMAND
DECODE AND
CONTROL
LOGIC
X5325 = RESET
SCK
8kBITS
8kBITS
CS/WDI
V
THRESHOLD
RESET LOGIC
CC
16kBITS
POWER-ON AND
LOW VOLTAGE
RESET
V
+
-
CC
GENERATION
V
TRIP
FN8131 Rev 3.00
December 9, 2015
Page 1 of 19