5秒后页面跳转
X4283_06 PDF预览

X4283_06

更新时间: 2024-11-23 03:15:23
品牌 Logo 应用领域
英特矽尔 - INTERSIL 监控可编程只读存储器电动程控只读存储器电可擦编程只读存储器
页数 文件大小 规格书
22页 344K
描述
CPU Supervisor with 128K EEPROM

X4283_06 数据手册

 浏览型号X4283_06的Datasheet PDF文件第2页浏览型号X4283_06的Datasheet PDF文件第3页浏览型号X4283_06的Datasheet PDF文件第4页浏览型号X4283_06的Datasheet PDF文件第5页浏览型号X4283_06的Datasheet PDF文件第6页浏览型号X4283_06的Datasheet PDF文件第7页 
X4283, X4285  
®
128K, 16K x 8 Bit  
Data Sheet  
May 23, 2006  
FN8121.1  
DESCRIPTION  
CPU Supervisor with 128K EEPROM  
The X4283, X4285 combines four popular functions,  
Power-on Reset Control, Watchdog Timer, Supply  
Voltage Supervision, and Block Lock protect serial  
EEPROM memory in one package. This combination  
lowers system cost, reduces board space require-  
ments, and increases reliability.  
FEATURES  
• Selectable watchdog timer  
• Low V detection and reset assertion  
CC  
—Four standard reset threshold voltages  
—Adjust low V reset threshold voltage using  
CC  
special programming sequence  
Applying power to the device activates the power-on  
reset circuit which holds RESET/RESET active for a  
period of time. This allows the power supply and oscilla-  
tor to stabilize before the processor can execute code.  
—Reset signal valid to V = 1V  
CC  
• Low power CMOS  
—<20µA max standby current, watchdog on  
—<1µA standby current, watchdog OFF  
—3mA active current  
• 128Kbits of EEPROM  
—64 byte page write mode  
The Watchdog Timer provides an independent protec-  
tion mechanism for microcontrollers. When the micro-  
controller fails to restart a timer within a selectable  
time out interval, the device activates the  
RESET/RESET signal. The user selects the interval  
from three preset values. Once selected, the interval  
does not change, even after cycling the power.  
—Self-timed write cycle  
—5ms write cycle time (typical)  
• Built-in inadvertent write protection  
—Power-up/power-down protection circuitry  
—Protect 0, 1/4, 1/2, all or 64, 128, 256 or 512  
bytes of EEPROM array with programmable  
The device’s low V  
detection circuitry protects the  
CC  
user’s system from low voltage conditions, resetting  
the system when V falls below the set minimum V  
Block Lock protection  
CC  
CC  
• 400kHz 2-wire interface  
• 2.7V to 5.5V power supply operation  
• Available packages  
—8 Ld SOIC  
—8 Ld TSSOP  
trip point. RESET/RESET is asserted until V returns  
CC  
to proper operating level and stabilizes. Four industry  
standard Vtrip thresholds are available, however, Inter-  
sil’s unique circuits allow the threshold to be repro-  
grammed to meet custom requirements or to fine-tune  
the threshold for applications requiring higher precision.  
• Pb-free plus anneal available (RoHS compliant)  
BLOCK DIAGRAM  
Watchdog Transition  
Detector  
Watchdog  
Timer Reset  
WP  
Protect Logic  
RESET (X4283)  
RESET (X4285)  
Data  
Register  
SDA  
Status  
Register  
EEPROM Array  
Command  
Reset &  
Watchdog  
Timebase  
SCL  
Decode &  
Control  
Logic  
S0  
S1  
VCC Threshold  
Reset logic  
Power-on and  
Low Voltage  
+
-
VCC  
Reset  
Kb=Kilobyte  
Generation  
VTRIP  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.  
Copyright Intersil Americas Inc. 2005-2006. All Rights Reserved  
1
All other trademarks mentioned are the property of their respective owners.  

与X4283_06相关器件

型号 品牌 获取价格 描述 数据表
X4283AL XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283AM XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283AN XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283AP XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283F XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283G XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283I XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283S8 XICOR

获取价格

CPU Supervisor with 128K EEPROM
X4283S8 INTERSIL

获取价格

CPU Supervisor with 128K EEPROM
X4283S8-2.7 XICOR

获取价格

CPU Supervisor with 128K EEPROM