Low-Profile, Ultraminiature Lightweight SMT Coaxial Connectors - 0.94 or 1.2 mm Mated Height
X.FL Series
●Connector mated condition
Mated height comparison (compared to conventional company products)
X.FL-LP-040
X.FL-LP-032(09) X.FL-LP(P)-068
X.FL-PR-SMT1-2
X.FL-R-SMT-1 X.FL-R-SMT-1 X.FL-R-SMT-1
Fig. 1
Features
1. A Low mated height of 0.94 or 1.2
mm (maximum of 1.0 or 1.3 mm)
■
4. High frequency transmission
This series offers the high performance needed to
meet the requirements of many different
miniature devices, featuring a DC to 6 GHz
capacity. X.FL-LP(P)-068 supports up to 12 GHz.
When connected this series delivers a world class
low mated height of 1.0 or 1.3 mm (see Figure 1).
2. Minimal mounting area required
5. Automatic board placement
The receptacle requires a footprint of only 3.4 mm2,
which is the same footprint as our W.FL and W.
FL2 series. In addition, the same land patterns can
be used. (Note: The X.FL series has no mating
compatibility with the W.FL2 and W.FL series.)
This product is available in embossed
packaging; this allows the plug and receptacles
to be automatically mounted.
6.The use of ultra-fine coaxial
(fluorinated resin insulated) cables
3. Ultra lightweight
The use of ultra-fine coaxial (fluorinated resin
insulated) cables on these connectors offer the
ability to complete connections in small,
confined spaces with a smooth, easy operation.
The world’s smallest and lightest class of coaxial
connectors
Receptacle: 3.2 mg
Right angle plug: 22.0 mg (068),14.4 mg (040), and 15.7 mg (032)
Plug receptacle: 5.5 mg
7. Simple connector mating / unmating
Dedicated tools are available to ensure that proper
mating/unmating of this connector takes place.
Product Specifications
■
Nominal characteristic impedance
50ø
Operating temperature range -40°C to +90°C (RH 90% or less)
Ratings
Frequency range
DC~6GHz
Storage humidity range
-30°C to +70°C (RH 90% or less)
Specifications (for each plug type)
X.FL-LP-032(09) X.FL-LP(P)-068
Item
X.FL-LP-040
X.FL-PR-SMT1-2
1. Contact
resistance
(Center) Maximum of 20 mø (Center) Maximum of 25 mø (Center) Maximum of 25 mø (Center) Maximum of 25 mø
(Outer) Maximum of 10 mø (Outer) Maximum of 25 mø (Outer) Maximum of 10 mø (Outer) Maximum of 15 mø
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.7 or less (6 to 12 GHz)
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.3 or less (DC to 3 GHz)
1.5 or less (3 to 6 GHz)
2. V.S.W.R. (*)
3. Insulation resistance
4. Withstanding voltage
Minimum of 500 MΩ , 100 V DC
200 V AC, 1 minute
*V.S.W.R. Measurement System (plug type)
The above V.S.W.R. specification values were measured using the measurement system shown below.
Note 1:Cable type connectors were measured with SMA
conversion adapters attached to both ends of the
harness product of a suitable 100 cm cable.
Note 2:Board type connectors were mounted to a 50
glass epoxy board and measurements were
conducted with SMA conversion adapters
attached.
NetworkꢀAnalyzer
TestꢀSet
TestꢀPort
D.U.T
Termination
Test Port Cable
1
2014.1