MOSEL VITELIC
V58C265164S
Mode Register Set Timing
T0
T1
T2
T3
T4
T5
T6
T7
T8
T9
t
t
t
MRD
RP
CK
CK, CK
Pre- All
MRS/EMRS
ANY
Command
Mode Register set (MRS) or Extended Mode Register Set (EMRS) can be issued only when all banks are in the idle state.
If a MRS command is issued to reset the DLL, then an additional 200 clocks must occur prior to issuing any new command
to allow time for the DLL to lock onto the clock.
Burst Mode Operation
Burst Mode Operation is used to provide a constant flow of data to memory locations (Write cycle), or from
memory locations (Read cycle). Two parameters define how the burst mode will operate: burst sequence and
burst length. These parameters are programmable and are determined by address bits A —A during the
0
3
Mode Register Set command. Burst type defines the sequence in which the burst data will be delivered or
stored to the SDRAM. Two types of burst sequence are supported: sequential and interleave. The burst
length controls the number of bits that will be output after a Read command, or the number of bits to be input
after a Write command. The burst length can be programmed to values of 2, 4, or 8. See the Burst Length
and Sequence table below for programming information.
Burst Length and Sequence
Burst Length
Starting Length (A , A , A )
Sequential Mode
0, 1
Interleave Mode
0, 1
2
1
0
xx0
xx1
x00
x01
x10
x11
000
001
010
011
100
101
110
111
2
1, 0
1, 0
0, 1, 2, 3
0, 1, 2, 3
1, 2, 3, 0
1, 0, 3, 2
4
2, 3, 0, 1
2, 3, 0, 1
3, 0, 1, 2
3, 2, 1, 0
0,1, 2, 3, 4, 5, 6, 7
1, 2, 3, 4, 5, 6, 7, 0
2, 3, 4, 5, 6, 7, 0, 1
3, 4, 5, 6, 7, 0, 1, 2
4, 5, 6, 7, 0, 1, 2, 3
5, 6, 7, 0, 1, 2, 3, 4
6, 7, 0, 1, 2, 3, 4, 5, 6
7, 0, 1, 2, 3, 4, 5, 6
0,1, 2, 3, 4, 5, 6, 7
1, 0, 3, 2, 5, 4, 7, 6
2, 3, 0, 1, 6, 7, 4, 5
3, 2, 1, 0, 7, 6, 5, 4
4, 5, 6, 7, 0, 1, 2, 3
5, 4, 7, 6, 1, 0, 3, 2
6, 7, 4, 5, 2, 3, 0, 1
7, 6, 5, 4, 3, 2, 1, 0
8
V58C265164S Rev. 1.7 August 2001
7