UCD3138064
SLUSB72D – MARCH 2013 – REVIUSECDDA3P1R3IL82006241
www.ti.com
SLUSB72D – MARCH 2013 – REVISED APRIL 2021
UCD3138064 Highly Integrated Digital Controller for Isolated Power With 64-kB
Program Flash Memory
– Cycle-by-cycle current limiting
– Programmable blanking time and fault counting
– External fault inputs
Synchronization of DPWM waveforms between
multiple UCD3138 family devices
14-channel, 12-bit, 267-ksps general purpose ADC
with integrated
– Programmable averaging filters
– Dual sample and hold
1 Features
•
64 kB program flash derivative of UCD3138 family
– 2-32 kB program flash memory banks
– Supports execution from 1 bank, while
programming another
•
•
– Capability to update firmware without shutting
down the power supply
– Additional communication ports compared to
the UCD3138 (+1 SPI, +1 I2C)
•
•
Internal temperature sensor
– RGC and RJA packages pin-to-pin compatible
with UCD3138 (SLUSAP2B). Section 6.1
Digital control of up to 3 independent feedback
Loops
– Dedicated PID based hardware
– 2-pole/2-zero configurable, non-linear control
Up to 16-MHz error A/D converter (EADC)
– Configurable resolution (min: 1 mV/LSB)
– Up to 8x oversampling and adaptive trigger
positioning
Fully programmable high-performance 31.25-MHz,
32-bit ARM7TDMI-S processor
– 64-kB program flash (2-32-kB banks)
– 2-kB data flash with ECC
– 4-kB data RAM
– 8-kB boot ROM enables firmware bootload
Communication Peripherals
– 1 - I2C/PMBus, 1 - I2C (master mode only)
– 2 - UARTs
– 1 - SPI
•
•
•
– Hardware based averaging (up to 8x)
– 14-bit effective DAC
Up to 8 high resolution digital pulse width
modulated (DPWM) outputs
– 250-ps pulse width resolution
– 4-ns frequency and phase resolution
– Adjustable phase shift and dead-bands
– Cycle-by-cycle duty cycle matching
– Up to 2-MHz switching frequency
Configurable trailing, leading and triangular
modulation
•
•
•
•
•
Timer capture with selectable input pins
Built in watchdog: BOD and POR
64-pin QFN, and 40-pin QFN packages
Operating temperature: –40°C to 125°C
Fusion digital power studio GUI support
•
2 Applications
•
•
•
Power supplies and telecom rectifiers
Power factor correction
Isolated DC-to-DC modules
•
•
Configurable feedback control
– Voltage, average current and peak current
mode control
– Constant current, constant power
Configurable FM, phase shift modulation and
PWM
Fast, Automatic and smooth mode switching
– Frequency modulation and PWM
– Phase shift modulation and PWM
High efficiency and light load management
– Burst mode and ideal diode emulation
– Synchronous rectifier soft on and off
– Low device standby power
•
•
•
•
•
Primary side voltage sensing
Flux and phase current balancing for non-peak
current mode control applications
Current share
•
•
Feature rich fault protection options
– 7 analog and 4 digital domparators,
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
Product Folder Links: UCD3138064
Copyright © 2021 Texas Instruments Incorporated
Submit Document Feedback
1