5秒后页面跳转
UCC1583 PDF预览

UCC1583

更新时间: 2024-11-04 12:47:15
品牌 Logo 应用领域
德州仪器 - TI 稳压器开关
页数 文件大小 规格书
10页 409K
描述
Switch Mode Secondary Side Post Regulator

UCC1583 数据手册

 浏览型号UCC1583的Datasheet PDF文件第2页浏览型号UCC1583的Datasheet PDF文件第3页浏览型号UCC1583的Datasheet PDF文件第4页浏览型号UCC1583的Datasheet PDF文件第5页浏览型号UCC1583的Datasheet PDF文件第6页浏览型号UCC1583的Datasheet PDF文件第7页 
UCC1583  
UCC2583  
UCC3583  
Switch Mode Secondary Side Post Regulator  
FEATURES  
DESCRIPTION  
Precision Secondary Side Post  
Regulation for Multiple Output Power  
Supplies  
The UCC3583 is a synchronizable secondary side post regulator for preci-  
sion regulation of the auxiliary outputs of multiple output power supplies. It  
contains a leading edge pulse width modulator, which generates the gate  
drive signal for a FET power switch connected in series with the rectifying  
diode. The turn-on of the power switch is delayed from the leading edge of  
the secondary power pulse to regulate the output voltage. The UCC3583  
contains a ramp generator slaved to the secondary power pulse, a voltage  
error amplifier, a current error amplifier, a PWM comparator and associ-  
ated logic, a gate driver, a precision reference, and protection circuitry.  
Useful for Both Single Ended and  
Center Tapped Secondary Circuits  
Ideal Replacement for Complex  
Magnetic Amplifier Regulated Circuits  
Leading Edge Modulation  
The ramp discharge and termination of the gate drive signal are triggered  
by the synchronization pulse, typically derived from the falling edge of the  
transformer secondary voltage. The ramp starts charging again once its  
low threshold is reached. The gate drive signal is turned on when the ramp  
voltage exceeds the control voltage. This leading edge modulation tech-  
nique prevents instability when the UCC3583 is used in peak current mode  
primary controlled systems.  
Does Not Require Gate Drive  
Transformer  
High Frequency (>500kHz) Operation  
Applicable for Wide Range of Output  
Voltages  
High Current Gate Driver (0.5A  
The controller operates from a floating power supply referenced to the out-  
put voltage being controlled. It features an undervoltage lockout (UVLO)  
circuit, a soft start circuit, and an averaging current limit amplifier. The cur-  
rent limit can be programmed to be proportional to the output voltage, thus  
achieving foldback operation to minimize the dissipation under short circuit  
conditions.  
Sink/1.5A Source)  
Average Current Limiting Loop  
(continued)  
TYPICAL APPLICATION AND BLOCK DIAGRAM  
UDG-96201-2  
Note: Pin connections shown for 14-pin packages.  
11/98  

与UCC1583相关器件

型号 品牌 获取价格 描述 数据表
UCC1583D TI

获取价格

1.8A SWITCHING CONTROLLER, 500kHz SWITCHING FREQ-MAX, PDSO14, SOIC-14
UCC1583J TI

获取价格

1.8A SWITCHING CONTROLLER, 500kHz SWITCHING FREQ-MAX, CDIP14, CERAMIC, DIP-14
UCC1583N TI

获取价格

1.8A SWITCHING CONTROLLER, 500kHz SWITCHING FREQ-MAX, PDIP14, PLASTIC, DIP-14
UCC1585J TI

获取价格

1A SWITCHING CONTROLLER, 700kHz SWITCHING FREQ-MAX, CDIP16, DIP-16
UCC1588-1D TI

获取价格

1A SWITCHING CONTROLLER, 700kHz SWITCHING FREQ-MAX, PDSO16, SOIC-16
UCC1588-1PW TI

获取价格

1A SWITCHING CONTROLLER, 700kHz SWITCHING FREQ-MAX, PDSO16, TSSOP-16
UCC1588D TI

获取价格

1A SWITCHING CONTROLLER, 700kHz SWITCHING FREQ-MAX, PDSO16, SOIC-16
UCC1588N TI

获取价格

1A SWITCHING CONTROLLER, 700kHz SWITCHING FREQ-MAX, PDIP16, PLASTIC, DIP-16
UCC17423J TI

获取价格

3A 2 CHANNEL, BUF OR INV BASED MOSFET DRIVER, CDIP8, CERAMIC, DIP-8
UCC17424J TI

获取价格

3A 2 CHANNEL, BUF OR INV BASED MOSFET DRIVER, CDIP8, CERAMIC, DIP-8